Paradox DGP2-648 User Manual page 23

How do I program a user access code?
1) Enter your [System Master Code] or [Access Code] with
Master feature.
2) Press the [0] key to enter the User Programming Menu. The area
lights of areas assigned to your User Access Code and the P
action light will flash.
3) Press the [Acc] key. The area lights of the areas assigned to
your User Access Code and the A
illuminate. The P
4) Enter either a 2-digit User Number (02 to 96 for a Digiplex 848
system) or a 3-digit number (002 to 999 for a DigiplexNE system)
you wish to program. The A
unused code. If the code is used, P
number of the code will illuminate. The A
light will turn off.
5) Enter a User Code. If you do not want to change an existing one,
[ ]
press the
emit a Half Beep when it switches to User Options. Pre-existing
options will illuminate.
6) Program the User Options (Table 1 on page 22) by turning the
options "ON" or "OFF". Once the options are programmed, press
[ ]
the key to reach the Area Assignment. Your keypad will emit
a Half Beep when it switches to Area Assignment. Pre-existing
assignments will illuminate.
7) Program the Area Assignment (Table 2 on page 25). Press the
[ ]
key to return to User Options or press [Enter] to save and
exit. Your keypad will emit a Confirmation Beep to confirm the
code's acceptance.
action light will continue to flash.
RG
CCESS
key until you reach User Options. Your keypad will
Digiplex 848/DigiplexNE LED Keypads
action light will
CCESS
action light will flash for an
action light and the first
RG
action and area
CCESS
RG
21n