Nexgrill 720-0607 Assembly & Operating Instructions
  1. Manuals
  2. Brands
  3. Nexgrill Manuals
  4. Grill
  5. 720-0607
  6. Assembly & operating instructions
Nexgrill 720-0607 Assembly & Operating Instructions

Nexgrill 720-0607 Assembly & Operating Instructions

For outdoor use only
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
ASSEMBLY & OPERATING INSTRUCTIONS
Model: 720-0607
FOR OUTDOOR USE ONLY
FOR PROPANE GAS USE ONLY
L17Y07P_1
This instructions manual contains important information necessary for the proper assembly and safe use of the appliance.
Read and follow all warnings and instructions before assembling and using the appliance
1
Follow all warnings and instructions when using the appliance
Keep this manual for future reference

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 720-0607 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Nexgrill 720-0607

Summary of Contents for Nexgrill 720-0607

  • Page 1 ASSEMBLY & OPERATING INSTRUCTIONS Model: 720-0607 FOR OUTDOOR USE ONLY FOR PROPANE GAS USE ONLY L17Y07P_1 This instructions manual contains important information necessary for the proper assembly and safe use of the appliance. Read and follow all warnings and instructions before assembling and using the appliance...

  • Page 2: Table Of Contents

    Table of Contents Safety Instruction ..... Care and Maintenance ....29-30 Assembly Instruction .

  • Page 3: Safety Instruction

    Safety Instruction continued WARNING ELECTRICAL GROUNDING INSTRUCTIONS This appliance (rotisserie motor) is equipped with a plug and should be plugged directly into a properly grounded receptacle. When installed, must be electrically grounded in accordance with local codes or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 or the Canadian Electrical Code, CSA C22.1 DO NOT cut or remove the grounding prong from this plug.

  • Page 4: Model

    Safety Instruction continued WARNING CAUTION: Beware of Flashback CAUTION: Spiders and small insects occasionally Do not try lighting this appliance without reading the spin webs or make nest in the grill “LIGHTING INSTRUCTIONS” section of this manual. burner tubes during transit and warehousing.
  • Page 5 Safety Instruction continued LP-Gas Supply System PROPER PLACEMENT AND CLEARANCE OF If the information is not followed exactly, a fire resulting in death or GRILL serious injury could occur. A 20lb tank of approximately 12 inches in diameter by 18-1/4 inches •Never use your gas grill in a garage, porch, shed, high is the maximum size LP gas tank to use.
  • Page 6 Safety Instruction continued SAFETY PRACTICES TO AVOID PERSONAL WARNING INJURY Your grill will get very hot. Never lean over the cooking area while using your grill. Do not touch When properly cared for, your grill will provide safe, cooking surfaces, grill housing, lid or any other grill reliable service for many years.
  • Page 7 Safety Instruction continued Do not heat unopened food containers. A build-up of Do not use the grill to cook excessively fatty meats or pressure may cause the containers to burst. other products which promote flare – ups. Use a covered hand when opening the grill lid. Do not operate the grill under unprotected combustible constructions.

  • Page 8: Assembly Instruction

    Assembly Instruction continued Caster Assembly: A. Screw the two Swivel casters onto the bottom of left side panel leg . B. Screw two straight casters to the right side of bottom panel with 8pcs ¼” screws.
  • Page 9 Assembly Instruction continued Side Panel and Back Panel Assembly: Attach the right & left side panel to the bottom panel respectively and screw the bottom of each side panel with 2pcs ¼’’ screws from outside to inside . B. Attach the back panel to bottom panel & side panel, secure the back panel with bottom panel from inside with 3pcs 5/32”...
  • Page 10 Assembly Instruction continued Diagonal Bar barrier and Front Frame Assembly: A. Attach the two diagonal Bar Barrier to pre-drilled hole on back panel and bottom panel , screw them with 4pcs 5/32” screws. B. Attach the front cart frame to pre-drilled hole of the left & right side panel, tighten them with 4 pcs 1/4” screws.
  • Page 11 Assembly Instruction continued C. The 6pcs triangle brackets have been assembled on the corner of cart frame, then screw each tripod with 2pcs 5/32’’ screws. Door Assembly: Attach the right & left door with door hinge to the right and left side panel, then screw the each door with 6pcs 5/32”...
  • Page 12 Assembly Instruction continued Firebox Assembly: A. Place the firebox on the cart frame horizontally & gently and make the side burner gas valve across the hole of the right side panel. ( need two or three persons lift the firebox up since the firebox is heavy) .
  • Page 13 Assembly Instruction continued Side shelf and Side Burner Assembly: Assemble the side shelf to the left side panel and the side burner to the right side panel respectively with 4pcs ¼*15 mm screws, as the figure show below. Attention: the side shelf and side burner should be similarly screwed the packing.
  • Page 14 Assembly Instruction continued E: Install the brass connector into the side burner pipe. tighten the brass connector to the side burner pipe bracket by wrench. then connect the igniter wire to the valve, see figure below. F: Attach the knob to the knob bezel and using the Allen wrench which was in hardware bag to tighten it .
  • Page 15 Assembly Instruction continued G: Attach bottle opener to side burner panel and screw it with 2pcs 1/4’’ screws .
  • Page 16 Assembly Instruction continued J: Remove the ignition button housing cap. Insert the battery into the housing with the positive(+) terminal facing outward. Screw the ignition button housing back into place. H: Place 1pcs grease tray to the bottom of side burner and 2pcs grease tray to the bottom of main firebox.
  • Page 17 Assembly Instruction continued I: Using 2pcs 5/32” screws secure the rotisserie motor bracket , then install the motor on motor bracket and insert the spit rod with forks and scarf collar shown in the figure below. J: Raise the gas tank retention ring located inside the cart on the right panel. place gas tank into the gas tank hole.
  • Page 18 Assembly Instruction continued PROPANE TANK ASSEMBLY Attach propane gas tank to regulator inlet fitting by turning the regulator clockwise as shown below. Hand frighten. LP gas cylinder must be fitted with a listed overfill prevention device (OPD) CAUTION! DO NOT USE TOOLS TO ATTACH REGULATOR / HOSE ASSEMBLY TO PROPANE TANK Lift the tank retention ring located inside the cart and attach to bracket under the heat shield.

  • Page 19: Gas Hook -Up

    Gas Hook - Up NEVER CONNECT AN UNREGULATED GAS SUPPLY QCC1 in the standard for compressed gas cylinder LINE TO THE APPLIANCE. USE THE valve outlet and inlet connection ANSI/CGA-V-1. REGULATOR/HOSE ASSEMBLY SUPPLIED. Manifold pressure: 11”(27.94cm) water column (W.C.). This is a liquid propane configured grill. Do not attempt L.P.

  • Page 20: Installer Final Check List

    Gas Hook – Up continued 5. When connecting regulator assembly to the valve, 7. If you have a gas connection leak you cannot repair, hand tighten the quick coupling nut clockwise to a turn gas OFF at supply tank, disconnect fuel line complete stop.

  • Page 21: Leak Testing

    Leak Testing GENERAL Only those parts recommended by the manufacturer should be used on the grill. Although all gas connections on the grill are leak tested at the factory prior to shipment, a complete gas Substitution will void the warranty. Do not use the grill tightness check must be performed at the installation until all connections have been checked and do not site due to possible mishandling in shipment, or...
  • Page 22 Leak Testing continued CAUTIONS Place dust cap on cylinder valve outlet when the cylinder is not in use. Only install the type of dust cap on the cylinder valve outlet that is provided with the cylinder valve. Other types of caps or plugs may result in leakage of propane. The gas must be turned off at the supply cylinder when the unit is not in use.

  • Page 23: Operating Instruction

    Operating Instruction GENERAL USE OF THE GRILL AND ROTISSERIE WARNING: IMPORTANT! Each main burner is rated at 14,000 Btu/hr. The main USING THE SIDE BURNER: grill burners encompass the entire cooking area and Inspect the gas supply hose prior to turning the gas are side ported to minimize blockage from falling “ON”.

  • Page 24: Grill Lighting Instruction

    Grill Lighting Instruction WARNING: IMPORTANT! TO LIGHT THE MAIN BURNER: BEFORE LIGHTING… Never substitute regulators and hose assembly for those supplied with the grill. If a replacement is Inspect the gas supply hose prior to turning the gas necessary, contact the manufacturer for proper “ON”.

  • Page 25: Grill Lighting Instruction

    Grill Lighting Instruction continued FLAME CHARACTERISTICS Check for proper burner flame characteristics. Burner flames should be blue and stable with no yellow tips, excessive noise, or lifting. If any of these conditions exist call our customer service line. If the flame is yellow, it indicates insufficient air. If the flame is noisy and tends to lift away from the burner, it indicates to much air Each burner is adjusted prior to shipment;...

  • Page 26: Lighting Illustration

    Lighting Illustration Rear Burner Lighting Illustration : Main & Side Burner Lighting Illustration: Push and turn Rear Burner knob slowly to IGNITE/ON. Hold in until the burner is lit. Step 1. Once it is lit, continue to press and hold for Make sure the Lid is open another 15 seconds to ensure the burner stays lit.

  • Page 27: To Match The Light Grill

    To Match the Light Grill If the burner will not light after several attempts then the burner can be match lit. If you have attempted to light the main burners with the igniter, allow 5 minutes for any accumulated gas to dissipate. Insert a match into the lighting rod.

  • Page 28: Motor Instruction

    Motor Instruction • TO USE MOTOR SAFELY, PLEASE READ WARNING PRIOR TO USE ROTISSERIE DRIVE MOTOR USE ONLY FOR OUTDOORS. DO NOT EXPOSE TO RAIN. CAUTION: TO ENSURE CONTINUED PROTECTION AGAINST RISK OF ELECTRIC SHOCK, CONNECT TO PROPERLY GROUNDED OUTLETS ONLY, TO REDUCE THE RISK OF ELECTRIC SHOCK, KEEP EXTENSION CORD CONNECTION DRY AND OFF THE GROUND.

  • Page 29: Care And Maintenance

    Care and Maintenance MAIN GRILL BURNER CLEANING STAINLESS STEEL Ensure the gas supply is off and the knobs are in the There are many different stainless steel cleaners “OFF” position. Make sure the grill is cool. Clean the available. Always use the mildest cleaning procedure exterior of the burner with a wire brush.
  • Page 30 Care and Maintenance continued STAINLESS STEEL : HOW TO REPLACE MAIN BURNER There are many different stainless steel cleaners Step 1. Insert the burner onto the orifice. available. Always use the mildest cleaning procedure first, scrubbing in the direction of the grain. Do not use steel wool as it will scratch the surface.

  • Page 31: Trouble Shooting

    Trouble Shooting SPIDER AND INSECT WARNING WHEN TO LOOK FOR SPIDERS You should inspect the burners at least once a year or immediately after any of the following conditions occur: Checking and cleaning burner/ venturi tubes for insects and insect nests. A clogged tube can lead to a 1.
  • Page 32 Trouble Shooting continued PREHEATING: The grill lid should be in a closed position during the preheat time period. It is necessary to preheat the grill before cooking certain foods, depending on the type of food and the cooking temperature. Food that requires a high cooking temperature needs a pre-heat period of five minutes;...
  • Page 33 Trouble Shooting continued PROBLEM SOLUTION When attempting to light my grill, it will not • Make sure you have a spark while you are trying to light light immediately. the burner (if no spark) • Ensure that the wire is connected to the electrode assembly.
  • Page 34 Trouble Shooting continued Rotisserie motor will not turn • Ensure the motor is connected to a properly grounded power supply. • Ensure the on / off switch is in the on position. • Ensure that the spit is fully inserted into the rotisserie motor •...

  • Page 36: Part List

    Part List Part (Description) Part (Description) Main control panel Main lid screw cover Main lid screw A Control knob Main lid screw B Grease slide panel , bottom Main lid hinge spacer Small main burner grease slide panel Temperature Gauge heat insulating spacer Grease tray Temperature Gauge Small main burner grease tray...
  • Page 37 Part List Continued Part (Description) Part (Description) Rubber grommet Rotisserie burner flex gas line Back Panel Rotisserie orifice w/brass elbow Side burner flex gas line Main burner igniter wire A Side Burner brass connector Main burner igniter wire B Side Burner hose Main burner igniter wire C Searing burner Igniter wire Question mark main burner igniter wire...

  • Page 38: Ordering Parts

    If you wish to convert at which products was purchased. If dealer service is some later date, be sure to contact your gas supplier or not available, contact: Nexgrill Industries, Inc. grill dealer before making the conversion. customer service...

  • Page 39: Grill Cooking Chart

    Grill Cooking Chart WEIGHT OR HEAT APPROXIMATE SPECIAL INSTRUCTIONS FOOD THICKNESS SETTING TIME AND TIPS Slice. Dot with butter or margarine. Wrap in VEGETABLES heavy -duty foil. Grill, turning occasionally Medium 12 to 20 minutes Grill, turning once. Brush occasionally with Fresh melted butter or margarine.

  • Page 40: Grill Cooking Chart

    Grill Cooking Chart continued WEIGHT OR HEAT APPROXIMATE SPECIAL INSTRUCTIONS FOOD THICKNESS SETTING TIME AND TIPS PORK Trim edges. Grill, turning once. Cook to Chops 1 inch Medium 20 to 30 minutes desired doneness. 1 -1/2 Well -done inches Medium 30 to 40 minutes Grill, turning occasionally.

  • Page 41: Grill Recipe Suggestion

    Grill Recipe Suggestion continued BBQ SALMON TANGY SEAFOOD KABOBS BBQ the chops brushing with the marinade occasionally. Serve with 1 lb. Large shrimp, shelled & 2 large salmon steaks deveined mixed salad, dressed with 2 tbs. Oil vinaigrette flavored with fresh dill. ¾...
  • Page 42 Grill Recipe Suggestion continued In blender, process 1/3 c. water, Preheat grill. Combine cheese, Pound flank steak to ¼ inch condensed soup, milk, BBQ sauce, thickness or flatten chicken breasts. onion, soy sauce, 2 tsp. oil and the oregano, salt and pepper in a large Mix oil, lime juice and seasonings next 8 ingredients until smooth.
  • Page 43 Grill Recipe Suggestion continued CHICKEN TANDOORI STYLE Marinade ribs for 3 hours. Use TURKEY marinade for basting by adding 8 large chicken thighs or 12 lb. turkey drumsticks beer to it. Place pan under the ribs Beer basting sauce: and baste frequently. To cook ribs 1 c.

  • Page 44: Limited Warranty

    Limited Warranty...

Table of Contents