GE ZBD5900 Technical Service Manual page 63

5.2.47 Door Handle Cover Plate - 5600, 5700 &
5900 Models
CAUTION. Switch off electrical power supply.
5.2.47.1 Remove the door handle (Section 5.2.46).
5.2.47.2 Grasp the flange of the door handle cover plate
which protrudes below the bottom edge of the carrier panel
and spring both retaining tabs from the carrier panel.
Door handle cover plate
5.2.47.3 Remove the door handle cover plate spring. Refer
to the picture below.
5.2.47.4 Reassemble the dishwasher in reverse order.
5.2.47.5 Operate and test the dishwasher before leaving.
5.2.48 Door Lock Microswitch - 5600, 5700 & 5900
Models
5.2.48.1 Remove both wires from the microswitch and snip
the retaining wire tie from the body of the microswitch.
5.2.48.2
microswitch and the surface of the carrier panel. With a pair
of needle nose pliers, insert a tip of the pliers into the
adjacent mounting hole of the carrier panel. Position the
other tip of the pliers on the microswitch top retainer clip and
carefully release the retainer clip. At the same time, lift the
microswitch with the small screwdriver, which will assist in its
removal.
5.2.48.3 Repeat the procedure with the lower retainer clip,
although the clip will require unlatching without the aid of a
mounting hole. Carefully lift the microswitch from the two
mounting posts and lift clear. Reassemble the dishwasher in
the reverse order. To reinstall the microswitch, a replace-
ment wire tie is required.
5.2.48.4 Operate and test the dishwasher before leaving.
Spring
62
CAUTION. Switch off electrical power supply.
Slide the tip of a small screw driver between the