GE ZBD5900 Technical Service Manual page 55

5.2.33.4 Grasp each hose in turn and disconnect them
from the pump cover nozzles.
5.2.33.5 Removal of the three outlet hoses now provides
access to the centrally mounted induction/inlet nozzle of the
pump cover. Compress the double coil hose clamp located
on the inlet hose and slide the clamp from the nozzle
towards the sump as shown below.
Move the double coil hose clamp away from wash pump/
motor.
Chassis hook Motor hooks
NOTE: The wash motor/pump is actually supported by the
short hose between the wash motor/pump and the corre-
sponding nozzle of the sump.
5.2.33.6 The rear end of the wash motor is supported by a
triangular, detachable, neoprene mounting support strap,
which is attached to a hook located on the left hand rear
chassis panel. On the rear diecast end-shield of the wash
motor are support hooks.
triangular mounting support strap are attached to those
hooks to support the wash motor. Refer to the photo above
which has the rubber triangular mounting support strap
removed to clearly show the hooks.
5.2.33.7 Two options are available to remove the wash
motor triangular neoprene mounting support strap:
1. Twist the mounting support strap and push the locating
hole from the front hook on the wash motor end-shield as
shown above right. Push the mounting support strap up
and release the mounting support strap from the hook
located on the chassis panel. The rear locating hole of
the mounting support strap can then be disengaged from
the hook on the wash motor end-shield. The wash motor
mounting support strap can then be lifted clear of the
dishwasher.
OR
2. Remove the retaining screw which mounts the hook onto
the chassis panel. Detach both locating holes in the
mounting support strap from both hooks on the wash
motor end-shield. Lift clear the mounting support strap
and the detached chassis hook from the appliance.
The two lower holes of the
5.2.33.8 The wash motor/pump can then be withdrawn from
the pump cover inlet hose, as shown below, and lifted clear
as a complete assembly.
5.2.33.9 Reinstall the wash motor/pump and reassemble the
dishwasher in reverse order or refer to section 5.2.34 if the
wash motor/pump needs to be disassembled.
CAUTION. Test for water leaks before leaving.
5.2.33.10 Operate and test the dishwasher before leaving.
54