GE ZBD5900 Technical Service Manual page 36

Internal cross
brace
Two screws on
lower return
edge of door
panel
5.2.2.6 Reinstalling the door panel to the dishwasher
requires the three Phillips headed stainless steel screws
fitted to each side of the door to be replaced in reverse order
as section 5.2.2.2
5.2.2.7 The cross brace may not seat against the internal
surface of the stainless steel door liner, hence the two
stainless steel Phillips headed screws will not reach the
surface of the cross brace and cannot engage with the
threads on the cross brace. If this occurs, bend the cross
brace slightly away from the door panel. This should supply
enough tension for the cross brace to press against the door
liner while the screws are being reinstalled.
5.2.2.8 Make certain the "O rings" are in place on the cross
brace screws and reinstall.
5.2.2.9 Operate and test the dishwasher before leaving.
5.2.3 Door Panel Assembly - 5900 Models
CAUTION. Switch off electrical power supply.
NOTE: The 5900 Model does not have a separate
control panel. All controls are included in the door
panel.
5.2.3.1 Refer to section 5.2.2.1 for removal of the 2 stainless
steel Phillips head screws located at the bottom of the
stainless steel door liner.
5.2.3.2 Remove the 4 Phillips Head countersunk stainless
steel screws located across the top of the stainless steel
door liner.
NOTE: The 4 screws have a "two start" or dual thread
configuration. One thread is of a low profile while the other is
of a high profile in order to prevent stripping of the carrier
panel fixing points.
5.2.3.3 Remove the three Phillips head stainless steel
screws fitted to each side of the door to enable the door
panel to be withdrawn from the stainless steel door liner.
While removing the six stainless steel screws, ensure the
door panel is supported. It is suggested to leave one central
screw loose and in place for support while removing the
three stainless steel screws on each side of the door.
5.2.3.4 Lift the door panel clear. The control components
will remain on the door panel but give access to both internal
and external components.
NOTE: The wiring harness will restrict movement of the door
panel.
5.2.3.5 Reassemble the dishwasher in reverse order.
5.2.3.5 Operate and test the dishwasher before leaving.
35
Door liner
Door Panel