Side Floor Frame; Ramp - Arrow Storage Products 697.68222 Owner's Manual & Assembly Instructions

Step 1
SV14
The front floor frame is made up of
three pieces. The side floor frames
and the rear floor frame are made up
of two pieces. The holes in these
pieces will align when the pieces are
positioned with correct amount of
overlap. The illustrations below show
the proper overall length for the sides,
rear and front. Proceed as follows:
1
Place the front floor frames as
shown. Center the ramp, with drain
holes facing outside, on top of the two
front floor frames. Join the frames by
inserting eight screws.
2
Overlap the side floor frames and
the rear floor frames as shown. The
holes in these pieces will align when
the pieces are positioned with cor-
rect amount of overlap. See the illus-
trations below for the proper overall
length of the side and rear floor frames.
Join the frames by inserting four/five
bolts into each frame set as shown.
3
Double check the length of each
and set these pieces aside for later
use.
14
● Parts Needed For ●
Floor Frame Assemblies
10392
STEP
1
9367
10392
STEP
2
STEP
3
● ● ● ● ● 8934 Ramp (1)
● ● ● ● ● 9367 Front Floor Frame (2)
● ● ● ● ● 8936 Rear Floor Frame (2)
● ● ● ● ● 10392 Side Floor Frame (4)
9367
8934
9367
8934
DRAIN HOLES FACE
OUTSIDE
Side Floor Frame 141 5/8" 359,7cm
8936
119 3/8" 303,2cm
119 3/8" 303,2cm
8936
Front Floor
Frame Assembly
119 3/8" 303,2cm
9367
10392
Rear Floor Frame 119 3/8"
303,2cm
8936
141 5/8" 359,7cm
Sides
141 5/8" 359,7cm
Front & Rear