Advertisement
Step 1
XN11
(8)
The front fl oor frame is made up of
three pieces. The side fl oor frames
and the rear fl oor frame are made
up of two pieces. The holes in these
pieces will align when the pieces are
positioned with correct amount of
overlap. The illustrations below show
the proper overall length for the sides,
rear and front. Proceed as follows:
1
Place the front fl oor frames as
shown. Center the ramp, with drain
holes facing outside, on top of the two
front fl oor frames. Join the frames by
inserting eight screws.
2
Overlap the side fl oor frames
and the rear fl oor frames as shown.
The holes in these pieces will align
when the pieces are positioned with
correct amount of overlap. See the
illustrations below for the proper over-
all length of the side and rear fl oor
frames. Join the frames by inserting
four/fi ve bolts into each frame set as
shown.
3
Double check the length of each
and set these pieces aside for later
use.
Parts Needed For
Floor Frame Assemblies
(13)
STEP
1
STEP
2
9367
8934
10392
9367
DRAIN HOLES FACE
OUTSIDE
10392
8936
STEP
3
14
8934 Ramp (1)
9367 Front Floor Frame (2)
8936 Rear Floor Frame (2)
10392 Side Floor Frame (4)
9367
8936
8934
9367
Side Floor Frame 141 5/8" 359,7 cm
10392
Rear Floor Frame 119 3/8"
141 5/8" 359,7 cm
Sides
141 5/8" 359,7 cm
119 3/8" 303,2 cm
Front & Rear
119 3/8" 303,2 cm
Front Floor
Frame Assembly
119 3/8" 303,2 cm
303,2 cm
8936
Advertisement
