Step 1
SV14
® Parts Needed For ®
Floor Frame Assemblies
• 8934 Ramp (1)
• 9367 Front Floor Frame (2)
• 8936 Rear Floor Frame (2)
• 10392 Side Floor Frame (4)
The front floor frame is made up of
three pieces. The side floor frames
and the rear floor frame are made up
of two pieces.
The holes
in these
pieces will align when the pieces are
positioned
with correct
amount
of
overlap. The illustrations
below show
the proper overall length for the sides,
rear and front. Proceed as follows:
8934
.
.
9367
1 Place the front
floor
frames
as
shown. Center the ramp, with drain
holes facing outside, on top of the two
front floor frames. Join the frames by
inserting eight screws.
2 Overlap the side floor frames
and
the rear floor frames as shown. The
holes in these pieces will align when
the pieces are positioned
with cor-
rect amount of overlap. See the illus-
trations
below for the proper overall
length of the side and rear floor frames.
Join the frames by inserting four/five
bolts into each frame set as shown.
3 Double check the length of each
and set these pieces aside for later
9!?
f_
Front Floor
_'_
8934
i?._,I I
Frame Assembly
___
_
1193/8"
303,20m
L
9367
i_/!
_
t t_ i
9367
,,
======...'DRAIN HOLES FACE
OUTSIDE
use.
14