Table of Contents
Advertisement
,m
=.
Step 1
$O14
• Parts Needed For ®
Floor Frame Assemblies
O 8934 Ramp (1)
O 9367 Front Floor Frame (2)
® 8938 Rear Floor Frame (2)
O 10387 Side Floor Frame (4)
The front floor frame is made up of
three pieces. The side floor frames
and the rear floor frame are made up
of two pieces.
The holes
in these
pieces will align when the pieces are
positioned
with correct
amount
of
overlap. The illustrations
below show
the proper overall length for the sides,
rear and front. Proceed as follows:
8934
9367
8936
I
Place the front
floor
frames
as
shown. Center the ramp, with drain
holes facing outside, on top of the two
front floor frames. Join the frames by
inserting eight screws.
2 Overlap the side floor frames and
the rear floor frames
as shown. The
holes in these pieces will align when
the pieces are positioned
with cor-
rect amount of overlap. See the illus-
trations below for the proper overall
length of the side and rear floor frames.
Join the frames by inserting fourlfive
bolts into each frame set as shown.
3
Double check the length of each
and set these pieces aside for later
use.
??
f_
Front Floor
?_
8934 _
Frame Assembly
_#_
119 3/8" 3,0m
L____.J
9367
_DRAIN
HOLES FACE_:.9
OUTSIDE
14
Advertisement
Table of Contents
