Installing The Thermostat; Disassembly; Thermostat Location; Mounting The Subbase - Jackson Systems T-32-TS Touchscreen Thermostat Installation Manual

INSTALLING THE THERMOSTAT

DISASSEMBLY

There are two release slots located on the bottom of the thermostat. Gently push the
flat blade of a small screwdriver into one slot at a time and pry upward until the catch
disengages. Carefully swing the thermostat upward and away from the subbase.

THERMOSTAT LOCATION

The T-32-TS should be installed in a location that
represents the ambient space temperature. Do not
install the thermostat in an area where drafts are
present, near the floor, behind doors or on an
external wall. Avoid placing the thermostat in
areas where the air movement is limited, affected
by direct sunlight or other areas not typical of the
temperature in the space.

MOUNTING THE SUBBASE

When mounting the T-32-TS subbase, be aware
that drafts may travel down wall cavities and enter
the back of the thermostat through the control
wire hole in the wall. It is important to seal the
FIGURE 1
6