Thermostat Installer Options; Setting The Zone Number; Setting The Home Number - Jackson Systems WCT-32 Installation Manual

7

Thermostat Installer Options

The installer options can be accessed by
pressing and holding the ENTER key for seven
seconds. The LCD displays Option 01 for setting
the Zone number. (See Installer Options Chart)
Press or hold the NEXT key to advance to the
next option. The LCD will advance through to
Option 16 and then return to Option 01.
Press the ENTER key to save all options in non-
volatile flash ram.
If only one wireless thermostat and HVAC Control
Module are used in an application, the thermostat
can be left with the factory default setting of Zone
= 01 and Home = 01.
If multiple wireless thermostats and HVAC
Control Modules are used that are less than 500
feet away from one another, each thermostat
must be set to a different Home number. For
convenience, set the Installer Options with the
thermostat off the subbase and in easy access of
its HVAC Control Module.
8

Setting the Zone Number

Use the Up and Down keys to set the Zone
number for the each thermostat. The Zone
number can be set from 01 to 08.
Option
CANCEL
Zone Numbers can be used to identify individual
thermostats. Press the NEXT key to advance to
the next option. Press the ENTER key if no more
options are to be changed.
Zone
NEXT
ENTER
Installer Options Chart
Option Description
01 Zone number
Range 01 to 08
Default 01
02 Home number
Range 01 to 32
Default 01
03 Program HVAC module with Zone
and Home address - Default 01
04 Equipment type
Range 00- G/E 01- Heat Pump
Default 00- G/E
05 Indoor Fan Operation
Range 00- Gas 01- Electric
Default 00- Gas
06 Minimum Off Time
Range 01 to 09 minutes
Default 00 minutes
07 Minimum Run Time
Range 01 to 09 minutes
Default 00 minutes
08 Maximum allowable heating setpoint
Range 60 to 85F
Default 85F
09 Minimum allowable cooling setpoint
Range 55 to 80F
Default 65F
10 Heat/Cool Setpoint Differential
Range 02 to 06F
Default 02F
11 Stage 1 Temperature Differential
Range 01 to 04F
Default 01F
12 Stage 2 Temperature Differential
Range 01 to 10F
Default 03F
13 Stage 3 Temperature Differential
Range 01 to 12F
Default 05F
14 Staging Time
Range 0 = OFF 1 = ON
Default 0
15 Staging Time When 14 = 1 (ON)
Range 15 - 30 (1 Minute Increments)
Default 15
16 Automatic Backup
Range 00- Off 01- On
Default 01- On
17 Temperature Calibration
Range 40 - 95
Default Factory Calibrated
9

Setting the Home number

Press the NEXT key to select Option 02. The
Home number is used to distinguish between
thermostats and HVAC Control Modules that are
less than 500 feet away from one another. This
could be a home with two HVAC systems or a
multi-family residence.
4