Outdoor Sensor Wiring - Jackson Systems T-32-TS Touchscreen Thermostat Installation Manual

REMOTE SENSOR INSTALLATION

OUTDOOR SENSOR WIRING

When the T-32-S1 is used as an outdoor sensor, the T-32-TS thermostat will display the
outside air temperature as well as control high and low balance points for heat pump
and fossil fuel systems. Refer to 18:TT in the installer setup menu to select the proper
sensor option. The outdoor sensor wires to the SC and S2 terminals on the thermostat.
Figure 7 illustrates both an indoor and outdoor sensor configuration. Mount the
sensor on a vertical exterior surface below an overhang. Choose a location protected
from direct sunlight and exposure to excessive moisture. Follow the same wiring
procedures as installing an indoor sensor.
FIGURE 7
S2 SC S1
OUTDOOR SENSOR INDOOR SENSOR
T-32-S1 T-32-S1
SENSOR SENSOR
50