Getting Started; Installing The Thermostat - Jackson Systems Comfort System T-32-P Installation Manual

GETTING STARTED

As with any HVAC project, careful installation is the key to a successful outcome. Time taken during
the installation process will be rewarded with fewer call-backs.
The steps required to install the T-32-P thermostat are as follows:
1. Read and understand this Installation Manual and Operation Manual.
2. Mount the T-32-P.
3. Set the 8 system switches to match the equipment application.
4. Wire the optional remote temperature sensor(s) or devices.
5. Power the thermostat.
6. Set the Advanced Installer Setup options.
7. Program and setup the T-32-P thermostat. (Refer to the Operation
Manual for instructions)
8. Test heating, cooling and other functions.

INSTALLING THE THERMOSTAT

DISASSEMBLY
Insert a small coin (dime) in the release slot located
on the bottom of the thermostat. Gently twist the coin
to release the thermostat from the subbase. Avoid
twisting the case as this may stress the LCD or bend
the terminal connector pins. (Figure 1)
THERMOSTAT LOCATION
The T-32-P should be installed in a location that
represents the ambient space temperature. Do not
install the thermostat in an area where drafts are
present, near the floor, behind doors or on an external
wall. Avoid placing the thermostat in areas where the
air movement is limited, affected by direct sunlight or
other areas not typical of the temperature in the
space.
MOUNTING THE SUBBASE
When mounting the T-32-P, be aware that drafts may
travel down wall cavities and enter the back of the
thermostat through the control wire hole in the wall. It
is important to seal the hole to prevent any drafts that
might affect the internal temperature sensor.
FIGURE 1
2