Table of Contents
Advertisement
Quick Tips & Tricks:
Problem: The Puck LED readout says "
Solution: The Puck is in Slave mode with no master fixture connected.
Press <MENU>, select "
<ENTER> to confirm. The unit will reset after approximately 10 seconds.
Problem: The Puck is only displaying certain colors (an entire color group of LEDs is dimly
lit or entirely off.)
Solution: The manual color adjustments have been set at levels less than the full intensity
for each color.
Press <MENU>, select "
bLuE, ANbE or WHIt
should be left in this mode unless setting a custom standalone color (See page 9. Should
the problem persist, please contact technical support.
Problem: The fade you've selected is too fast/too slow.
Solution: Press <MENU>, select "
and select the speed by selecting "
Troubleshooting
Symptom
Fixture Auto-Shut
Off
Beam is Dim
No Light Output
Chase Speed Too
Fast/Slow
No Power
Slow Movement
No Response to
Audio
Fixture Not
Responding /
Responding Er-
ratically
The Puck™ Fab5 Skywire Manual Rev. A
SLNd
," hit <ENTER>, select "
MANu
," and ensure that all of the color settings (
) are set to
Solution
Check the fan in the fixture. If it is stopped or moving slower than
normal, the unit may have shut itself off due to high heat. This is to
protect the fixture from overheating. Clear the fan of obstructions,
or return the unit for service.
Check optical system and clean excess dust/grime. Also ensure that
the 220V/110V switch is in the correct position, if applicable.
Check to ensure fixture is operating under correct mode, IE sound
active/auto/DMX/Etc., if applicable. Contact service for more infor-
mation.
Check to ensure proper setup of speed adjustment.
Check fuse, AC cord and circuit for malfunction.
Verify that 220V/110V switch is in the correct position, if applicable.
Also check that speed channels are set appropriately.
Verify that the fixture is in "Sound Active" mode.
Adjust Audio Sensitivity, If Applicable.
Make sure all connectors are seated properly and securely.
Use Only DMX Cables.
Install a Terminator.
Check all cables for defects.
Reset fixture(s).
If your problem isn't listed, or if problems persist,
please contact support: support@blizzardlighting.com.
StbY
," (Standby), no output."
255
. This is the maximum value and the fixture
SHNd
," hit <ENTER>, select "
SP 1
SP 8
,". 1 is the fastest, 8 is the slowest.
-
Page 12
NASt
" by pressing up or down, hit
rEd, GrEE,
FAdE
," hit <ENTER>,
Copyright (c) 2013 Blizzard Lighting, LLC
Advertisement
Table of Contents
