Monitoring The Operation Status; Status Monitor Mode - Toshiba TOSVERT VF-S11 Instruction Manual

5. Monitoring the operation status

Refer to 4.1 about flow of monitor.
5.1

Status monitor mode

5.1.1 Status monitor under normal conditions
In this mode, you can monitor the operation status of the inverter.
To display the operation status during normal operation:
Press the
Setting procedure (eg. operation at 60Hz)
Item displayed
Parameter setting
mode
Direction of
rotation
Operation
Note 1
frequency
command
Note 2
Output current
Note 3 Input voltage
Output voltage
Torque
Torque current
Inverter load factor
PBR overload
factor
Input power
Output power
Operation
frequency
(Continued overleaf)
key twice.
MODE
Key LED
operated display
.

MODE

MODE








k


Communic
ation No.
The operation frequency is displayed (Operation at
60Hz). (When standard monitor display selection
 is set at 0 [operation frequency])
The first basic parameter "" (history function)
is displayed.
The direction of rotation is displayed.
FE01
(: forward run, : reverse run)
The operation frequency command value (Hz/free
FE02 unit) is displayed.
The inverter output current (load current) (%/A) is
FE03
displayed.
The inverter input (DC detection) voltage (%/V) is
FE04
displayed.
FE05 The inverter output voltage (%/V) is displayed.
FE18 The torque (%) is displayed.
FE20 The torque current (%/A) is displayed.
FE27 The inverter load factor (%) is displayed.
The overload factor of the braking resistor (%) is
FE25
displayed.
FE29 The inverter input power (kW) is displayed.
FE30 The inverter output power (kW) is displayed.
The operation frequency (Hz/free unit) is
FD00
displayed.
39
E6581160
Description
5