Attaching The Belt Clip To The Handset; Rechargeable Battery Packs And The Charger - Inter-Tel INT2000 User Manual

Attaching The Belt Clip To The Handset

You can use the Belt Clip to attach the Handset to your belt or pocket for con-
venient portability.
1. Snap the tab out of the Belt Clip
notch on the top of the Handset.
2. Slide the clip into the tab slot.
The Belt Clip is designed to fit
snugly into the Handset.
3. Press firmly until the Belt Clip
snaps into place.
4. To remove, simply press the re-
taining clip in toward the Belt
Clip blade and slide the clip up
at the same time. Once the Belt
Clip is removed, remember to
re-install the cover tab.

Rechargeable Battery Packs And The Charger

NOTE: You can only use your INT2000 with the Handset when it is out of the
Battery Charger.
The rechargeable Battery Pack must be fully charged before using your
INT2000 for the first time (this requires 6-8 hours).
The unique design of your INT2000 allows you to place the Handset in the
Battery Charger with or without the Belt Clip attached. The Battery Charger
also has the ability to charge a second battery with or without the Handset be-
ing charged. The Battery Packs can automatically be recharged either in or
out of the Handset.
Rechargeable batteries can develop a reduced charge capacity caused by re-
peated charge and discharge cycles. The battery life will seem to be shorter
every time you use the unit. To avoid reduced charge capacity, operate the
unit until theBATT LOW indicator appears. Do this at least once a month.
Avoid "topping off" the charge after using the phone for a short time.
Inter-Tel INT2000 User Guide
5