K-array KA10-10 User Manual page 2

SYMBOLS
This symbol, wherever it appears, alerts you to
i m p o r t a n t o p e r a t i n g a n d m a i n t e n a n c e
istructions in the accompanying literature.
Read the manual!
For information about the disposal of Waste
Electrical and Electronic Equipment (WEEE),
please refer to the website at
www.scanning.datalogic.com
1. SAFETY INSTRUCTIONS
!
CAUTION
• To reduce the risk of electric shock, disconnect the amplifier from the AC mains before installing audio
cable. Reconnect the power cord only after making all signal connections.
• Connect the amplifier to a two-pole, three wire grounding mains receptacle. The receptacle must be
connected to a fuse or circuit breaker. Connection to any other type of receptacle poses a shock hazard and
may violate local electrical codes.
• Do not install the amplifier in wet or humid locations without using weather protection.
• Do not allow water or any foreign object to get inside the amplifier. Do not put objects containing liquid on,
or near, the unit.
• To reduce the risk of overheating the amplifier, avoid exposing it to direct sunlight. Do not install the unit
near heat emitting appliances, such as a room heater or stove.
• No naked flame sources such like lighted candles should be placed on the device.
• The amplifier should be placed so that its location does not interfere with its proper ventilation. For
example, the appliance should not be situated on a bed, carpet, or similar surface that may create an
obstacle for the ventilation openings.
• This amplifier contains potentially hazardous voltages. Do not attempt to disassemble the unit. The unit
contains no user serviceable parts. Repairs should be performed only by factory trained service personnel.
• Be sure that both voltage set by the selector on the device and AC Power have the same value.
USER'S MANUAL
!
Warning! Dangerous voltages: risck of electric
schock.
This symbol alerts the user to the presence of
recommendations about
maintenance.
!
product's use and
P. 2