Adjustment Of Cutting Height - Husqvarna WG3213P/968999114 Operator's Manual

Adjustment of cutting height

The cutting height can be adjusted by three
methods:
• Moving spacers between the upper side
and the lower side of the caster swivel
according to "Cutting height table". For
instruction, see below.
• Moving spacers between the upper side
and the lower side of the blades
according to "Cutting height table". For
removing and installation of blades, refer
to "Blade replacement" on page 46.
• Rear axle height adjustment according to
the following instruction.
1. To adjust rear axle, stop engine and
place motion control levers in the neutral
lock position, remove spark plug wires.
2. Remove lower belt shield from underside
of rear deck for better access to axle
adjustment bolts.
3. Loosen axle pivot bolts and axle
adjustment bolts.
4. Place a jack under center of rear deck
raise the jack slightly so axle adjustment
bolts may be removed.
5. With the jack raise or lower the rear deck
to the desired position using the chart to
ensure proper height.
6. Reinstall the axle adjustment bolts and
tighten. A tapered punch may be used to
help align the holes.
7. Using the "Cutting height table", find the
correct number of spacers to be placed
under the caster swivel
8. Remove the lynch pin and washer from
the top of caster and reposition spacers
to the desired cutting height from the
table. See illustration.
IMPORTANT INFORMATION
It may be necessary to readjust drive and
brake linkages.
IMPORTANT INFORMATION
To achieve the best quality cut, the blades
should be level with the ground or slightly
tipped forward.
OPERATION
1. Axle pivot bolt
2. Securing bolts (Loosen each side)
A-D. Axle adjustment bolts
Rear axle height adjustment
1. Machinery bushing
2. Caster swivel
3. ½" "C" Spacers
Caster height adjustment
8011-408
8011-405
31
English-