Husqvarna WG3213P/968999114 Operator's Manual page 55

Checking the Oil Level
The importance of checking and maintaining
the proper oil level in the crankcase cannot
be overemphasized.
Check oil before each use as follows:
1. Make sure the engine is stopped, level,
and is cool so the oil has had time to
drain into the oil pan.
2. To keep dirt, debris, etc., out of the
engine, clean the area around the
dipstick before removing it.
3. Unthread and remove the dipstick; wipe
oil off. Reinsert the dipstick into the tube
and rest the cap on the tube. Do not
thread the cap onto the tube.
4. Pull the dipstick out and check the oil
level. The oil level should be up to, but
not over, the "FULL" mark on the
dipstick.
5. If the level is low, add oil of the proper
type, to the "FULL" mark on the dipstick.
Refer to Oil Type, page 54. Always check
the level with the dipstick before adding
more oil.
IMPORTANT INFORMATION
To prevent extensive engine wear or
damage, always maintain the proper oil
level in the crankcase. Never operate the
engine with the oil level below the "ADD"
mark or over the "FULL" mark on the
dipstick.
LUBRICATION
Oil dipstick
Level marking
8011-471
8009-464
53
English-