Husqvarna WG3213P/968999114 Operator's Manual page 26

IMPORTANT INFORMATION
Do not let recoil cord snap back by itself.
This may damage the cord or the recoil
starter assembly.
7. Pull the recoil starter grip slowly until you
feel compression, then pull it briskly.
If the engine won´t start in three pulls,
open the choke and try again.
8. Warm engine momentarily, then
disengage the choke until engine runs
smoothly, approximately 1/2 throttle.
WARNING!
Be sure all persons are
of area before engaging the
blades.
IMPORTANT INFORMATION
To prolong spindle bearing, clutch and belt
life engage and disengage blades at
approximately ½ throttle.
9. Depress one operator presence lever.
Engage the blades and set the desired
rpm. The best cutting and bagging is
obtained with engine at top rpm.
24
English-
OPERATION
Pull the starter grip
clear
Presence lever
Blade engaged
8011-498
8011-658
8011-694