Temporary Ringer Silencing; Temporary Tone Dialing; Find Handset - VTech CS6124-11 User Manual

Telephone operation

Temporary ringer silencing

When the telephone is ringing, you can temporarily silence the ringer of the
handset or telephone base without disconnecting the call. The next call rings
normally at the preset volume.
To silence the handset ringer:
Press OFF/
•
CANCEL
Ringer muted displays.
To silence the telephone base ringer:
/VOLUME once.
• Press

Temporary tone dialing

If you have pulse (rotary) service only, you can switch from pulse to tone dialing
temporarily during a call. This is useful if you need to send touch-tone signals to
access your telephone banking or long distance services.
1. During a call, press
2. Use the dialing keys to enter the number. The telephone sends
touch-tone signals.
3. The telephone automatically returns to pulse dialing mode after you end
the call.

Find handset

Use this feature to find all system handsets.
To start paging:
Press /FIND HANDSET on the telephone base
1.
once and then release when the telephone is not
in use.
All idle system handsets ring and ** Paging **
2.
flashes on the screen for 60 seconds.
To end paging:
Press /FIND HANDSET on the telephone base
•
once and then release.
-OR-
/
• Press
FLASH
stop the paging tone.
Do not press and hold /FIND HANDSET for more than four seconds. It may
lead to handset deregistration. If Not registered displays on the handset, refer to
Troubleshooting on page 34 to register the handset to the telephone base.
or MUTE/
DELETE
.
TONE
or any of the dialing keys (0-9,
and then
TONE
12
Ringer muted
10:15
PM
#
or ) on the handset to
12/25