Getting started
Telephone base and charger installation
Install the telephone base and charger as shown below.
If you subscribe to digital subscriber line (DSL) high-speed Internet service
through your telephone line, you must install a DSL filter between the telephone
line cord and telephone wall jack. Contact your DSL service provider for more
information about DSL filter.
Telephone
wall jack
A DSL filter (not
included) is
required if you have
DSL high-speed
Internet service
Telephone
line cord
•
Use only the power adapters supplied with this product.
•
The power adapters are intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
Wall mounting (optional)
Your telephone comes ready for tabletop use.
To mount your telephone on the wall:
1.
Position the top hole at the back
of the telephone base against the
top mounting stud [A].
2.
Slide the telephone base down
on the mounting studs [A] and [B]
until it locks into place.
Electrical outlet
(not controlled
by a wall switch)
Telephone base
power adapter
Telephone base
[A]
Mounting
studs
[B]
2
Charger
adapter
Charger
Telephone base