Gateway - Time - Ubee DDW3612 User Manual

3.7 Gateway
3.7.6
The Time option allows you to configure the system time obtained from network
servers via Simple Network Time Protocol (SNTP). The device must be reset for any
changes to take effect.
1. Access the web interface. Refer to
2. Click the Gateway link from the top of the screen.
3. Click Time from the left side of the screen. The Time fields are explained following
this screen example.
Label
26

Gateway - Time

Enable SNTP
Current Time
System Start Time
Time Server 1
Time Server 2
Time Server 3
Time Zone Offset
Apply
Reset Values
page 7, if needed.
Description
Click Yes to enable SNTP (Network Time Protocol). Click No
to disable the feature. SNTP is a protocol for synchronizing
the clocks of computing devices over networks.
Displays the current system time.
Displays the accumulated time since system was started.
Defines the Time server IP address or Domain name. Use the
one provided, or enter an alternative choice.
Defines the Time server IP address or Domain name. Use the
one provided, or enter an alternative choice.
Defines the Time server IP address or Domain name. Use the
one provided, or enter an alternative choice.
If needed, define the time zone offset in Hours and Minutes.
For example: 8 means GMT + 08, -1 means GMT -01.
Click Apply to save all screen changes
Click Reset Values to reset the screen to factory defaults.
DDW3612 Subscriber User Guide • July, 2010
Ubee Interactive