Checking The Tyre Pressure; Checking The Engine's Cooling Air Intake; Checking And Adjustment Of The Cutting Unit's Ground Pressure; Checking The Cutting Unit's Parallelism - Husqvarna R 214T AWD Operator's Manual

Checking the tyre pressure

The tyre pressure should be 60 kPa (0.6 bar / 9 PSI) all round.
To improve driving the pressure on the rear tyres can be
reduced to 40 kPa (0.4 bar/5.6 PSI). The maximum tyre
pressure is 100 kPa (1,0 bar/14 PSI).
CAUTION!
Having the same air pressure in the tyres is important in
order to achieve the best possible performance as well as
to avoid damage to the machine
Checking the engine's cooling air
intake
Clean the air intake grille in the engine cover behind the
driver's seat.
Open the engine cover.
Check that the cooling intake is free from leaves, grass and
dirt.
A blocked cooling intake will interfere with the cooling of the
engine, which can damage the engine.
WARNING! The cooling air intake rotates
!
when the engine is running. Mind your
fingers.
22 –
English
Maintenance
Checking and adjustment of the
cutting unit's ground pressure
To achieve the best cutting results the cutting unit should
follow the underlying surface without pressing too hard
against it.
Pressure is adjusted using a screw and spring on each side
of the Rider.
1 Check the air pressure in the tyres 60 kPa/0.6 kp/cm
PSI.
2 Place the machine on a flat surface.
3 Put the lifting lever in the mowing position.
4 Place a set of bathroom scales under the cutting unit's
frame (front edge) so that it rests on the scales. If
necessary a block can be placed between the frame and
scales so that the support wheels do not bear any weight.
5 Adjust the unit's ground pressure by screwing in or out the
adjusting screws located behind the front wheels on both
sides. The ground pressure should be between 12 and 15
kg (26.5-33 lb).
Checking the cutting unit's
parallelism
Check the cutting unit's parallelism as follows:
1 Check the air pressure in the tyres 60 kPa/0.6 kp/cm
PSI.
2 Place the machine on a flat surface.
3 Put the lifting lever in the mowing position.
4 Measure the distance between the ground and the front
and rear edges of the cutting unit hood. The cutting unit
should have a slight slant, with the rear edge 2-4 mm (1/
8") higher than the front edge.
2
/8.5
2
/8.5