SteelFlex CT1 User Manual page 37

ENGINEERING MODE
1. Unit setting
a. Take off safety key. Press "
until software version is showed.
b. ENGLISH and METRIC can be chosen and then press "
2. LED and Buttons checking
a. Take off safety key. Press Press "
b. All LED on the button board are lighted. Press buttons, LED
which corresponds to will be off. After all LED lights off, it will
go back to start condition.
ERROR CODE
1. When sensor switch is broken, speed error code will be showed
and display shows " ZERO SPEED ERROR-SET X.X ACT X.X".
2. When elevation motor is broken, elevation error code showed
and display shows " ELEVATION ERROR-SET XXXX ACT
XXXX".
3. If inverter is abnormal, display shows AC1~9 on the speed
window.
STOP STOP
"+ "elevation 3" and hold
RESET RESET
STOP STOP
" + "elevation 4".
RESET RESET
START START
"
ENTER ENTER
36