Table of Contents
Advertisement
S CLASS™ cutter
Panels:
There are 4 specific parameters in the 'Panels' submenu:
1. Panels: This parameter switches panels on or off.
2. Panel size: This parameter determines the length of the panel.
3. Panel replot: This parameter determines if the design has to be cut more than
once on top of itself, this per panel. Panel replot is used for thick media and
media which is difficult to cut. The value of this parameter is disregarded if
paneling is set to off. If this parameter is set at 0, then the cutter will cut each
panel only once. If it is set at 1, it will cut each panel twice,...
4. Sort vectors: With this parameter vector sorting can be set off or on. When
vector sorting is set on, then all vertical lines and horizontal lines are grouped
and the vertical lines (media movement direction) are all cut in the same
direction. It is not advised to set sorting on when paneling is set to off.
Paneling is used for several different applications. Below are the typical settings for
the most 3 common applications.
Cutting through: This is explained in section 3.5. Typical settings for the parameters
are then: Panels: ON; Panel size 5 – 10cm; Panel replot: OFF; vector sorting: ON.
Tracking difficult media: This is explained in section 2.7. Typical settings for the
parameters are then: Panels: ON; Panel size 3 – 10cm; Panel replot: ON/OFF
depending on the thickness of the media; vector sorting: ON/OFF depending on
needed knife pressure and backing of the material.
Roll Up: The roll-up system is an option that can be added on the larger S CLASS
models refer to the manual for the roll-up system for more info. Typical settings for the
parameters are then: Panels: ON; Panel size 50 – 100cm; Panel replot: OFF; vector
sorting: OFF. Another recommended setting when using the roll-up system is to set
panels to off and use the automatic paneling of 100cm and set roll-up to 'AFTER
AUTO-panel'. See section on 'Roll up media:'
Smoothing:
The Smoothing feature helps to cut smoother curves when curve data with many short
vectors is received from the computer.
Press the button, then use
Press
to confirm or
,
The default setting is OFF.
Concatenation:
The Concatenation feature increases the speed and quality with which very high-
resolution cut data is cut. However, when changing over to normal characters again,
deactivate concatenation by setting this parameter to 0.
Press the button, then use
Press
to confirm or
,
The default setting is 0.
Detailed Operation
or
to set smoothing to ON or OFF.
to cancel.
or
to change the value.
to cancel.
User's Manual
4-5
Advertisement
Table of Contents
