Clock Set Mode (Clock Setting; Energy Save Mode - Sharp R-898M Operation Manual

Clock Set Mode (Clock Setting)

If you set the clock (Clock Set Mode), Energy Save Mode
does not work.
* To enter the present time of day 11:34 (AM or PM).
Step
Press the CLOCK pad once.
1
Enter the hours by pressing the TIME pads.
2
Press the CLOCK pad once to change
from hours to minutes.
3
Enter the minutes by pressing the
TIME pads.
4
Press the CLOCK pad again.
5
This is a 12-hour clock. If the clock is set, when
cooking is complete, the display will show the
correct time of day. If the clock has not been set,
the display will only show ".0" when cooking is
complete.
If the electrical power supply to your microwave
oven is interrupted, plug in the oven again, then
open the door. The display will show:
ENERGY SAVE MODE TO CANCEL ENERGY SAVE
MODE SET THE CLOCK. If this occurs during
cooking, the programme will be erased. The time of
day will also be erased.
The clock of the oven works based on the
frequency of power source. So it may gain or
lose in some area where the frequency varies. It
Mode
Condition
No cooking or no operating
(Except Child Lock, Demo)
Child Lock Setting
Auto Start setting
Demostration Mode setting
Power Interruption
R-898M [SEID]_EN.indd Sec1:7 R-898M [SEID]_EN.indd Sec1:7
Procedure
x 1 x 1
x 3 x 4
The Display in Clock Set Mode or Energy Save Mode
Clock Set Mode
Current time
Current time
(Lock will be displayed by pressing a pad each time.)
Setting time
DEMO MICROWAVE OVEN
E – 7
is recommended that you should adjust the time
occasionally.
If you wish to know the time of day during the
cooking mode, press the CLOCK pad. As long as
your fi nger is pressed the CLOCK pad, the time of
day will be displayed.

Energy Save Mode

Your oven has an Energy Save Mode. In Energy
Save Mode approximately 0.1 watt is used, when
blank shows on the digital display. While in Clock
Set Mode approximately 3 watt is used as the time
will be shown. The Display in Clock Set Mode or
Energy Save Mode under different conditions is
listed below for your reference.
In Energy Save Mode, if you do not operate the
oven for 3 minutes or more (i.e. closing the door,
pressing the STOP/CLEAR pad, or at the end of
cooking), the display will be blank and the oven
cannot be used. To restore power on, open and
then close the door, ". 0" will be displayed and
the oven is ready for use.
If you set the clock, Energy Save Mode will be
cancelled.
To start Energy Save Mode manually, follow the
instructions below.
* To start the Energy Save Mode (the display
shows the time of day).
Procedure
Step
Press the CLOCK pad twice.
1
Press the INSTANT COOK/START pad.
2
The power will be off and the display
will show nothing.
Energy Save Mode
" .0" or Blank (without operating over 3 minutes)
" .0"
Auto Start can't be set in Energy Save Mode.
Blank
x 2
12/18/07 9:23:54 AM 12/18/07 9:23:54 AM