Before Operating; Getting Started; Clock Set Mode (Clock Setting) - Sharp Carousel R-890N Operation Manual And Cookbook

BEFORE OPERATING

Getting Started

Your oven has an Energy Save Mode. This facility saves electricity when the oven is not in use.
Step Procedure
Plug the oven into a power point and switch
1
on the power.
Open the door.
2
Close the door.
3
CAUTION:
In Energy Save Mode, if you do not operate the oven for 3 minutes or more (i.e. after closing the door, or pressing
the STOP/CLEAR pad, or at the end of cooking), you will not be able to operate the oven until you open and close
the oven door again.
NOTE: When you set Child Lock or Demonstration Mode, Energy Save Mode will be cancelled temporary.

Clock Set Mode (Clock Setting)

* To enter the present time of day 11:34 (AM or PM).
Step Procedure
Press the CLOCK pad.
1
Enter the correct time of day by press-
ing the numbers in sequence.
2
Press the CLOCK pad again.
3
This is a 12 hour clock. If you attempt to enter an incorrect clock time (Eg. 13:45) ERROR will appear in the
display. Press the STOP/CLEAR pad and re-enter the time of day (Eg. 1:45).
If the clock is set, when cooking is complete, the display will show the correct time of day. If the clock has not
been set, the display will only show ".0" when cooking is complete. If the electrical power supply to your
microwave oven is interrupted, plug in the oven again, then open the door. The display will show: ENERGY
SAVE MODE TO CANCEL ENERGY SAVE MODE SET THE CLOCK. If this occurs during cooking, the
programme will be erased. The time of day will also be erased. The clock of the oven works based on the
frequency of power source. So it may gain or lose in some area where the frequency varies. It is recommended
that you should adjust the time occasionally.
HELPFUL HINTS:
If you wish to know the time of day during the cooking or timer mode, press the CLOCK pad.
As long as your finger is pressed the CLOCK pad, the time of day will be displayed, if the clock is set.
Pad Order
CLOCK
CLOCK
7
Display
Nothing will be shown in the
display.
ENERGY, SAVE, MODE, TO,
CANCEL, ENERGY, SAVE,
MODE, SET THE,CLOCK will
be displayed.
Display
The dots (:) will flash on and
off.