Before Operating; Getting Started; Stop/Clear; To Cancel A Programme During Cooking - Sharp R-678P Operation Manual

BEFORE OPERATING

Getting Started

Your oven has an Energy Save Mode. This facility saves
electricity when the oven is not in use.
Step
Plug the oven into a power point.
1
Nothing will appear on the display at this time.
Open and close the door.
2
The display will show " . 0", and now you can
ready to use the oven.
CAUTION:
In Energy Save Mode, if you do not operate the oven for
3 minutes or more (i.e. after closing the door, or pressing the
STOP/CLEAR pad, or at the end of cooking), you will not be
able to operate the oven until you open and close the oven
door.
NOTE:
While the oven is in Demonstration mode, in Child Lock, or cooling
fan is working, Energy Save Mode will be cancelled temporary.

Stop/Clear

Press the STOP/CLEAR pad once to:
1. Stop the oven temporarily during cooking.
2. Clear if you make a mistake during programming.
To Cancel a Programme
During Cooking
Press the STOP/CLEAR pad twice.

Heating without Food

Some smoke and odor may occur for a while at the
beginning of GRILL, GRILL MIX or AUTO GRILL mode, but
the oven is not out of order.
To remove the cause of the smoke and odor, operate the
oven without food for 20 min. on Grill function before the
fi rst use and after cleaning.
Step
Ensure that no food is in the oven.
Press the GRILL pad.
1
Enter the heating time (20 min.).
2
Press the INSTANT COOK/START pad.
3
The timer will begin to count down. When it
reaches zero, audible signal will sound.
IMPORTANT:
During this operation, some smoke and odor will
occur. Therefore open the windows or run the
ventilation fan in the room.
R-678P [01 EN].indd 6 R-678P [01 EN].indd 6
Procedure
Procedure
x2
E – 6
Open the door to cool the oven cavity.
WARNING:
4
The oven door, outer cabinet and oven cavity
will become hot and pay attention to avoid
burn when cooling the oven.

Clock Set Mode (Clock Setting)

If you set the clock (Clock Set Mode), Energy Save Mode
does not work.
* To enter the present time of day 11:34 (AM or PM).
Step Procedure
Press the CLOCK pad once.
1
Enter the hours by pressing the TIME pads.
2
x1
The display will show
Press the CLOCK pad again.
3
The display will show
Enter the minutes by pressing the TIME pads.
4
x3
The display will be show
Press the CLOCK pad again.
5
The display will show time of day
This is a 12-hour clock. If the clock is set, when cooking is
complete, the display will show the correct time of day.
If the clock has not been set, the display will only show
".0" when cooking is complete.
If the electrical power supply to your microwave oven is
interrupted, plug in the oven again, then open and close
the door. The display will show: " .0 ". If this occurs during
cooking, the programme will be erased. The time of day
will also be erased.
The clock of the oven works based on the frequency of
power source. So it may gain or lose in some area where
the frequency varies. It is recommended that you should
adjust the time occasionally.
If you wish to know the time of day during the cooking
mode, press the CLOCK pad. As long as your fi nger is
pressed the CLOCK pad, the time of day will be displayed.
x1
x4
9/22/09 11:17:26 AM 9/22/09 11:17:26 AM