Wave Faucet Installation - Watts Premier RO-TFM-4SV Installation, Operation And Maintenance Manual

Wave Faucet Installation - Part# 116022
Note: If using the Wave Air Gap Faucet (pictured), a 1 1/4" hole will be required.
Step 6 Gather and identify the Wave faucet pieces.
Step 7 Remove black stem nut and insert the three tubes (air gap faucet)
through the white gasket with the groove on the gasket toward
the faucet base.
Step 8 Insert the three tubes through the 1 1/4" hole in the sink. The white
gasket must be on top side of the sink.
Step 9 View from under the sink and insert the white plastic spacer as shown.
Step 10 Thread the black stem nut back onto the white threaded stem and
tighten within ¼" of plastic spacer. Check the orientation of the faucet
above the sink and tighten the black plastic washer until white plastic
spacer is snug and faucet stands securely on top of the sink.
Note: A dripping or gurgling sound may be heard coming from the air gap
hole on the faucet or the drain when the system is running. This is
normal and in compliance with UPC (Universal Plumbing Code).
This unit comes equipped with an air-gap faucet. Air gap faucets are
Note:
a plumbing code requirement. The purpose of an air gap is to ensure
that the drain line from your RO unit does not get contaminated if your
sink backs up. If the sink does back up from blockage in or improper
installation of the drain line, water may come out of the vent hole in the
faucet.
Air Gap Faucet
Page 6
• Faucet assembly
• Black Shank Nut
• Spacer
• Gasket