[** Cm/S] Setting Cutting Speed - Roland Camm-1 PNC-1850 User Manual

** cm/s
Display readout
1 CUT 50cm/s
0.250mm 30gf
Factory default setting
50 cm/s
Settings range
1—85 cm/s (in increments of 1 cm/s)
When " HEAVY" is selected
for "WEIGHT" :
1—50 cm/s (in increments of 1 cm/s)
Procedure
This is set on the top menu.
Use the or keys to move the blinking cursor to the left of the top display
line (referred to below as the tool number). Use the
the tool number (1 to 8) that you wish to set the cutting parameters to.
First, set the values for "** cm/s" (cutting speed), "*.*** mm" (blade compensa-
tion), and "** gf" (blade force) on the same screen. Use the
move the blinking cursor to the item to be changed, and use the
to change the displayed values, and press
Press once. Use the
MENU
"SUBMENU" item at the right of the bottom line, and press
or keys to move the blinking cursor to "WEIGHT", and press
the value with the
Press to return to the initial screen, and press the
MENU
the blinking cursor to "UPSPEED". Press
change the value, and press
The values set for each item are now stored to the tool number shown at the left of
the top line. To store other parameters, display another tool number and repeat the
process.
Before cutting use the
number on the top menu, and press the
needed for the mounted current and sheet. When data is sent from the computer
cutting will be executed in accordance with those cutting parameters. Even if a
screen other than the top menu is displayed, cutting parameters will be those for
the tool number selected on the top menu.
When cutting is executed to a tool selection command (SP command) from the
computer, the PNC-1850/1200 tool number cutting parameters are set to match
the software (or driver). Turn on "TOOL-CHG" on the display menu. For
information on "TOOL-CHG", refer to "TOOL-CHG COMMAND Enabling tool
change commands" on page 30.
Setting cutting speed
Explanation
This sets the speed on the tool movement during cutting (i.e., when the tool is
down). The setting must match the conditions of the loaded sheet and blade.
Perform a cutting test and make the appropriate settings.
If "VS COMMAND" is set to "EFFECT," cutting is performed at the speed set
with the VS command send from the computer.
Procedure
This setting is made at the top menu.
Press or to move the blinking cursor to " ** cm/s" on the right side of the
upper line of the display.
Use and to change the value. Display the value for the setting and press
to save it.
ENTER
For more details, refer to "1-4-5 Cutting Test" on page 15.
ENTER to save them.
or keys to move the blinking cursor to the
or keys and press ENTER to save the value.
ENTER . Use the
ENTER to save it.
or keys to move the blinking cursor to the tool
and keys to select the tool number
and keys to display
or keys to
and keys
ENTER . Use the
ENTER
. Change
or keys to move
and keys to
23