When Using Rolled Sheet - Roland Camm-1 PNC-1850 User Manual

Turning on the Power
Switch on the power switch on the front of
the main unit.

When Using Rolled Sheet

When using stand
(PNC-1850: PNS-185, PNC-1200: PNS-121 (option))
(1) Mount the two shafts included with the stand on the sheet hanger and place a rolled sheet on top of the shafts.
(The shafts (2 pieces), stoppers (2 pieces), and stopper retaining screws (2 pieces) are included with the stand.)
Shafts
Sheet hangers
Front
Rear
(2) Pull out as much from the roll as needed, and pass the
sheet from the back of the main unit to the front as shown
in the figure.
At this time, pull the sheet straight out, so that the left and
right sides of the sheet are parallel to the legs of the stand.
Make sure that the edge of the sheet lies above the grit
rollers. Also check to make sure that the left and right
pinch rollers can be moved to the left and right edges of
the sheet.
To procedure (3)
When using sheet base
(PNC-1200 only)
(1) Set the accessory sheet base in back of the unit.
Place the sheet base parallel to the unit.
(2) Pass the end of the sheet between the pinch rollers and the
grit rollers so that it extends from the front of the unit.
Pull out some slack before you begin cutting.
To procedure (3)
Power ON
PNC-1850
PNC-1850
Roland DG Corp.
Install the shafts to match either
the remaining amount (roll width)
of the sheet, or the diameter of
the rolled sheet's core.
* Do not use with shafts installed
at both of these positions at the
same time.
If the diameter of the rolled sheet
core is 72 mm (2-7/8") or less
Install the shaft here if the amount
of sheet remaining is small.
* One shaft should always be
installed here.
Pass the stoppers onto
the shaft.
Tighten the stopper
retaining screws
provisionally.
Stopper
PNC-1200
PNC-1200
Roland DG Corp.
Shafts
Place the rolled
sheet here.
Front
Rear
Pull out the sheet so that it is parallel to the stand legs
Pass between the pinch roller
and grit rollers
Pull out so that there is
no slack on either side.
Rolled Sheet
Rear
Pull out the length to be
used from the rolled sheet
Sheet base
Place the sheet base parallel to the unit.
9