Roland Camm-1 PNC-1850 User Manual page 8

Sign maker

Table of Contents

Part 2

2-1

ABOUT THE CUTTING AREA ........................................................................................................................ 19

2-2

ABOUT THE BLADE ....................................................................................................................................... 19

2-3

DISPLAY MENUS FLOWCHART .................................................................................................................... 20

2-4

EXPLANATION OF DISPLAY MENU .............................................................................................................. 22

• Determining the type of sheet loaded

[SELECT SHEET] .................................................. 22

• Setting cutting conditions

[1-8] Selecting and storing cutting parameters .... 22

[** cm/s] Setting cutting speed ............................... 23

[*.*** mm] Setting blade compensation .................. 24

[** gf] Setting blade force ....................................... 24

[SMOOTHING] Cutting smooth curves .................. 24

[SHEET WEIGHT] Cutting thicker sheets .............. 25

[UP SPEED] Setting tool movement speed

• Setting the origin point

[ORIGIN SET] ........................................................ 25

• Rotating the origin point

[AXIS ROTATION] ................................................. 26

• Feed the loaded sheet

[AREA] .................................................................... 26

[AREA UNIT] .......................................................... 26

[PREFEED] ............................................................ 27

• Correct for the cutting distance error based on actual measurement

[CALIB] ................................................................... 27

• Repeating the same cutting - Deletes any data in the replot buffer

[REPLOT] ............................................................... 27

2-5

PLOTTING ON PAPER MEDIA ....................................................................................................................... 32

2-6

WHAT TO DO IF..... ......................................................................................................................................... 34

2-6-1 What to do if... ...................................................................................................................................... 34

2-6-2 Error messages .................................................................................................................................... 37

2-7

LIST OF CAMM-GL III INSTRUCTIONS ......................................................................................................... 38

2-8

DEVICE CONTROL INSTRUCTIONS ............................................................................................................. 41

Appendices

Appendix 1 CHARACTER SETS ............................................................................................................................. 43

Appendix 2 LIST OF OPTIONS ............................................................................................................................... 44

Appendix 3 SPECIFICATIONS ............................................................................................................................... 45

• Selecting the instruction set

[COMMAND MODE] .............................................. 28

• Selecting the connection interface

[INTERFACE] ......................................................... 28

• Setting the protocol for a serial connection

[STOP BIT] Stop bit ............................................... 28

[DATA BIT] Data bit ............................................... 29

[PARITY MODE] Parity check ................................ 29

[BAUD RATE] Baud rate ....................................... 29

[HANDSHAKE] Handshake ................................... 29

during tool-up ... 25

• Giving priority to settings from the computer