Table of Contents
Advertisement
DATA BIT
Display readout
DATA BIT
7 <8>
Factory default setting
8
Available settings
7 / 8
PARITY MODE
Display readout
PARITY MODE
<NONE>ODD EVEN
Factory default setting
NONE
Available settings
NONE / EVEN / ODD
BAUD RATE
Display readout
BAUD RATE
19200 <9600>
Factory default setting
9600
Available settings
2400 / 4800 / 9600 / 19200
HANDSHAKE
Display readout
HANDSHAKE
<H-WIRE>XON/OFF
Factory default setting
H-WIRE
Available settings
H-WIRE (Hardwire) / XON/OFF
Data bit
Explanation
The size (length) of one block of data.
Procedure
At the screen following selection of either "SERIAL" or "AUTO" for "INTER-
FACE," use
or
the lower line of the display, then press
Use
or
to change the value, and press
Parity check
Explanation
Parity is used to check whether data was received correctly.
Procedure
At the screen following selection of either "SERIAL" or "AUTO" for "INTER-
FACE," use
or
side of the lower line of the display, then press
Use
or
to change the value, and press
Baud rate
Explanation
Determines the speed of data transmission.
Procedure
At the screen following selection of either "SERIAL" or "AUTO" for "INTER-
FACE," press
.
MENU
Use
or
to move the blinking cursor to "BAUD" on the left side of the
lower line of the display, then press
Press
or
to change the value, and press
Handshake
Explanation
Sets the handshake mode for when the PNC-1850/1200 is connected the host
computer via the serial interface.
Procedure
At the screen following selection of either "SERIAL" or "AUTO" for "INTER-
FACE," press
.
MENU
Use
or
to move the blinking cursor to "HANDSHAKE" on the right side
of the lower line of the display, then press
Press
or
to change the value, and press
to move the blinking cursor to "DATA" in the center of
.
ENTER
ENTER
again to save the setting.
to move the blinking cursor to "PARITY" on the right
.
ENTER
again to save the setting.
ENTER
.
ENTER
ENTER
.
ENTER
ENTER
again to save the setting.
again to save the setting.
29
Hide quick links:
Advertisement
Table of Contents
