When Using A Flat Sheet (Standard-Size Sheet, Cut Sheet, Etc.) - Roland Camm-1 PNC-1850 User Manual

When Using a Flat Sheet (Standard-size Sheet, Cut Sheet, Etc.)

(1) Pass the sheet between the pinch rollers and the grit rollers.
(2) Move the two movable pinch rollers so that they are close
to the left and right edges of the sheet. When doing this,
make sure that the pinch rollers are positioned above the
grit rollers.
Three stickers indicating the locations of the grit rollers
are affixed to the back surface of the front cover. You can
use these stickers to confirm the locations of the grit
rollers when the grit rollers are hidden by the sheet.
If the pinch rollers are difficult to move, try moving the
sheet loading lever on the back of the unit at the same
time.
(3) Align the right edge of the sheet with the two guide lines located in
front of and behind the grit roller on the control panel side, and load
the sheet so that it is completely straight.
Lift the sheet loading lever on the back of the unit to lower the pinch
roller and clamp the sheet.
• Be sure to move the pinch rollers to positions above the grit rollers when securing a sheet in place.
If you try to load a sheet with the pinch rollers at locations that are not above grit rollers,
the message shown at right appears on the control panel. If this happens, raise the sheet
loading levers and move the pinch rollers to the proper positions above the grit rollers.
Reposition the sheet to match this new alignment, then lower the sheet loading levers to hold the sheet in place.
(4) When you close the front cover, the message shown at right appears on the control
panel. Press or to display "PIECE," then press the
carriage will move from side to side and the sheet will move forward and backward to
detect the size of the sheet. After this sensing is finished, the front edge of the sheet is
aligned with the cutting starting position.
(5) If sheet offset or alignment problems become apparent while the 1850/1200 is scanning
the piece in step (4) above, the sheet has not been loaded straight. Be sure to load the
sheet straight. Set the movable left and right pinch rollers inside the sheet edges.
• If the sheet curls toward the sheet face (cut face), it will cause the sheet to slip when loaded onto the PNC-
1850/1200, and may adversely affect cutting. In this case pre-bend the sheet downward so that the sheet edge
is not caught the front cover and guard bar during operation.
• If the sheet strikes the shaft that is installed on the stand, then remove the shaft.
Before attempting to move the pinch
roller, be sure to lower the sheet
loading lever to raise the pinch roller.
ENTER
Pass the sheet
Make sure the left and right margins are the same size
Stickers showing the locations of the
grit rollers
Sheet
Guide line
Change Pinch
Roller Position
Close the front cover
key. The tool
SELECT SHEET
ROLL EDGE PIECE
SELECT SHEET
ROLL EDGE PIECE
Move the pinch
rollers to inside
the edges of the
sheet
Guide line
Lift the sheet
loading levers
13