Panasonic 308 Installation Instructions Manual page 137

DBS
FF-1 System mode
SECTION 400 (Version 3.0)
Issue 1 January 1990
FFl-3#-17#-(O- 15)#
Dial pause timer for after obtaining
outside line
The time to when sending out the number dialed
starts after a connection with an outside line has
been made is set
For example. even if you start dialing immediately
after pressing the line key, the dial signal is sent
out to the outside line only after the specified time
has elapsed.
This setting is for when there is a risk of the dialing
tone from the switchboard of the connected CO.,
etc. being delayed or of a wrong connection being
made.
O#: 1.2 second after obtaining outside line
1#: 1.2 second after obtaining outside line
2#:2 seconds after obtaining outside line
3#:3 seconds after obtaining outside line
4#:4 seconds after obtaining outside line
58:s seconds after obtaining outside line
6#:6 seconds after obtaining outside line
7#:7 seconds after obtaining outside line
8#:8 seconds after obtaining outside line
9#:9 seconds after obtaining outside line
10s: 10 seconds after obtaining outside line
11#: 1 I seconds after obtaining outside line
12#: 12 seconds after obtaining outside line
13#: 13 seconds after obtaining outside line
14#:14 seconds after obtaining outside line
15#: 15 seconds after obtaining outside line
FFl-3#-18#-(0- 10)#
PBX connecting line flash time
The time (flash time) is set for temporarily
releasing the outside line when the [FLASHI'key or
IREDIAL] key has been pressed upon using a PBX
line forthe outside line.
This is only effective when the outside line is set as
the PBX line.
The outside line is released while the [FLASH] key
is pressed, even though this may be longer than
the time set for it
The time can be set within in range of 0 - 1 .l
seconds.
O#:No flash
1 #:Minimum line flash time of 0.2 seconds
Z#:Minimum line flash time of 0.3 seconds
3B:Minimum line flash time of 0.4 seconds
4B:Minimum line flash time of 0.5 seconds
5#:Minimum line flash time of 0.6 seconds
6#:Minimum line flash time of 0.7 seconds
7#:Minimum line flash time of 0.8 seconds
8#:Minimum line flash time of 0.9 seconds
9#:Minimum line flash time of 1.0 seconds
lo&Minimum line flash time of 1.1 seconds
-26-