Panasonic 308 Installation Instructions Manual page 125

DBS
FF-1 System mode
SECTION 400 (Version 3.0)
Issue 1 January 1990
FFl-2#-l#- 13#-(0 of I)#
Alternate attendants mode setting
This setting is for when 2 attendants phones have
been installed in the system.
When setting in the alternate mode, first call the
attendant's phone connected to extension port
No. 1. .
If this is busy, call the attendant's connected to
extension
pon No. 2.
OB: No alternate mode
1 R: Alternate mode
FFI-t#-I#-14#-(0 or I)#
Attendant calling mode
This specifies if the attendant's intercom call is
voice or tone. In addition, the attendant can
switch this setting on individual calls by dialing [ 1 I
after establishing an intercom call
O#: Tone call from attnndant
1%: Voice call from attendant
FFl-2#-l#-15#-(0 or l)#
Extension calling mode
This specifies if the extension's (except
attendant's) intercom call is voice or tone. In
addition, the attendant can switch this setting on
individual calls by dialing 11) after establishing an
intercom call
0%: Tone call
.l#: Voice call
FFl-2#-1#-16+(0 or l)#
Information tone setting for voice calling
When extension calling by voice, the information
tone (Splash tone "Pu..!') can first be sounded for
0.5 seconds from the extension of the party being
called.
This is specified when the extension calling mode
is set to voice call.
FFl-2#-1#-17#-(0 or l)#
Information tone setting for busy
override
When the conversation on an extension has been
interrupted, the information one is sent out to
the extension of the party being overridden to
indicate the fact
This setting notwithstanding, busy override
cannot be implemented for an extension involved
in a conference call.
It is necessary to have a setting regarding busy
override for each extension.
OS: No Information tone with in busv override
1#: Information tone sent out for busy override
FFl-2#-1#- 18#-(0 or l)#
System installation area setting
This specifies if necessary or not to the dial 1
before the area code when making calls to places
outside the area where the system is installed. If 1
is necessary when making calls to just some of the
areas, set 1 + Area. Calls o other areas for which 1
is not necessary are regarded as local calls and so
restricted by office codes, etc.
O#: No + 1 Area code location
I#: Necessarv the 1 + Area code location
FFl-2k1#-19#-(0or l)#
SSD name display mode
This specifiesthe quantity of names displayed on
the large display. The option is for 5 names or 10
names. When displaying 10 names the maximum
length shown will be 7 characters.
0#: Display 5 names in large display y "
%#?-Displav 10 names in lame disolay
08: No Information tone with in voice call
l#: Information tone sounds for voice call
-14-