Panasonic 308 Installation Instructions Manual page 124

SECTION 400 (Version 3.0)
issue 1 January 1990
DBS
FF-1 System mode
FFl-2#-l#-9#-(0 or l)#
Outside line automatic hold
(Key Bank Hold)
It is possible to set an extension for putting an
outside call on hold temporarily while making a
call on another outside line.
In this case the initiaicail is automatically put on
hold by pressing the FF key for the outside line you
intend to use for the other call without the need
for pressing the HOLD key.
A telephone call put on hold by this method is on
sy$tem hold.
O#: No automatic hold
1#: Automatic hold
FFl-2#-1#- 10#-(0 or I)#
Non - appearance outside line hold
This setting is for specifying whether a call on an
outside line not assigned to an FF key on your
extension is to be put on system hold
or
exclusive
hold.
This setting notwithstanding, it is not possible to
obtain another outside line during non -
appearance outside line hold.
0#: Exclusive hold
1 R: Svstem hold
Note 1: During non - appearance outside line put
on hold, the other outside line cannot
to
. be held.
Note 2: This function apples to Single Line
Telephone.
FFI-2#-I#-1 l#-(0 - 1)#
SLT Flash control
During a telephone call by SLTthe outside line can
be put
on
hold by lightly tapping the hook
button (hooking operation), and another outside
line or extension can then be telephoned.
This setting is for specifying whether to wait for
the intercom dial tone again orto release hold and
resume the initial outside call.
0#: Get new IDT to another TRF
1%: Retrieve held CO line
Note: Setting 0% here is related to setting the
SLT hooking flash timer.
FFI-2#-1#-12#-(0 or l)#
Extension number digit setting
This is for specifying whether the extension
number is to comprise 2 digits (Ext 10 - 69) or 3
digits (Ext 100 - 699). When over 60 extensions
are installed, the setting for 3 digits should be
done, before carrying out other settings.
By effecting this setting, the settings related to
extension groups and settings involving other
extension numbers all become invalid.
In addition, all the extension numbers and
functions assigned to the FF keys of each extension
are reset to their initial status.
At this time it is necessary to cut off the power for
the main cabinet once.
Warn enough when this setting will be done.
O##: 2 digits (Extension numbers 10 - 69)
1 #e 3 diuits (Extension num hers 100 - 699)
-13-