Panasonic 308 Installation Instructions Manual page 181

SECnON 400 (Version 3.0)
issue 1 January 1990
DBS
FF-8 LCR mode
FF&4#-( 1 - 4)#- (1 - 15)#-(000 - 999)#-(0 or l)#
Special
office code table storing
In order to find the cheapest outside line group to
be used from among the numbers starting with 6
digits when making an LCR call, the call is made in
accordance with the special office code for each
special area code specified by the time priority
table.
Rather than the area code or ofice code being
determined individually, a telephone number of
6
digits combining the special area code and special
office code is stored.
In this table are stored 4 special office code (000 -
999) tables corresponding to the 4 special area
codes.
The dial decided on forthe special office code is
derived from XXX as shown below.
(N=2-9,P=O-1,X=0-9)
1 + Area code : 1 - NPX-XXX-XXXX
NON 1 + Areacode: NPX-XXX-XXXX
Special office codes not stored in thistable cannot
be used for LCR calls. The structure for the data
storing in the table is as follows.
I (Time prioritytable number l-15)
Time priority table number 15#
I (Special Office code number l-4)
Special Office code Table Number 4#
Time prioritytable number l#
Special office code DATA:
(000-999)#-(Store:l or Delete:O)#
I (Time prioritytable number l-15)
Time prioritytable number 15#
Special office code DATA:
(OOO-999)#-(Store: 1 or Delete:O)#
NOTE 7:
For the system installation area it is
necessary to set either 1 + Area or
Non 1 + Area.
NOTE 2: LCR
calls cannot be made from outside
lines connected to a
PBX.
Special Office code Table Number 1#
Time prioritytable number 1#
Special office code DATA:
(OOO-999)#-(Store:1 or Delete:O)#
-69-