Panasonic 308 Installation Instructions Manual page 82

S-DBS Programming Instructions
v1.0
Section
400
Issue 1 July 1990 ,
(01-06) 05#-(0 or l)#
DTMF SIGNAL CONVERSION (AUTOMATIC)
The dial signal automatically converts to a DTMF signal within 15 seconds after
pulse dialing. Pressing #
or
*
is
not required.
However. during incoming calls the dial signal automatically converts immediately
without a 15-second intenral.
O#: Automatic conversion disable
l#: Automatic conversion enable
(01-06) 06#-(0 or l)#
DTMF SIGNAL CONVERSION (MANUAL)
Press # or * to convert the dial signal to a DTMF signal after
pulse
dialing.
__--. _-.__
_ -... .
O#: Conversion disable
l#: Conversion enable
(01-06) 07%(0 or l)#
DTMF SIGNAL SENDING TIME (AFTER DIALING)
When
time
o Y
ou change from pulse dialing to a DTMF signal during dialing the sending
the DTMF signal can also be changed.
O#: No change
l#: Changes length of the DTMF signal sending time
-
c ,i
NOTE: See Installation Instructions, Section 300 for
information on
how to
cut the jumper cable on
h-tern unit.
__-- .-
____-.---
38