Panasonic 308 Installation Instructions Manual page 146

SECTION 400 D/ersion 3.0)
Issue 1 January 1990
FF3-( 1 - 72)#-8#-(0 or l)#
Call waiting accept
setting
When a call is received'from another extension
while the extension is busy, the
busy
tone is sent
to the former.
However, this sets whether call waiting is to be
accepted or not when the 131 key has been input
again and call waiting effected. If set for
accepting, the incoming call signal is sent from the
. extension. But call waiting
cannot
be accepted by
an
extension which is set for absence, on hold,
receiving a call or involved in a conference call.
0#: Not accepting call waiting
1R: Acceotina call waitinq
FF3-(l- 72)#-9#-(0 or l)#
Busy
override call possibility setting
This sets for each extension whether busy override
is possible while it is in use.
Note that busy override is not possible when an
extension is set for rejecting it or by an extension
involved in a conference call.
0#: Busy override call imoossible
l#: Busy override call possible
FF3-( 1 - 72)#-1 OR- (0 or l)#
Busy
override
rejection setting
(Busy overridden)
This sets to accept busy override from another
extension or to reject it
0#: Busy override call rejected
l#: Busv override call accepted
Note : It is possible to have the setting so that the
signal will
sound during busy override to
indicate another busy override call.
DBS
FF-3 Extension mode
FF3-(1- 72)#-1 l#-(O or 1)s
Prime line pick-up setting
It is possible to have a setting for when making an
outside call to automatically pick up an outside
line stored in the FFl key simply by lifting the
handset However, this function will not operate if
the outside line has not been stored in the FFl key.
If Polled trunk access function has been set in the
FFl key, an available line is automatically accessed
by moving down in order from the extension port
with the largest number. As intercom calls cannot
be made with this setting however, "
#8"
[intercom call key] should be stored in another FF
key beforehand.
O#: No prime line function
I#: To pick up prime line
FF3-(1- 72)#-12k(0 or l)#
Automatic
incoming ring trunk pickup
By simply lifting the handset, the first of a number
of incoming trunk calls made is selected and
answered.
The setting can also be such that hold recall and
transferred calls can also be answered simply by
lifting the handset
O#: No automatic selection to ringing trunk
1%: Automaticallv select the rinaino trunk
FF3-U - 72)#-13#-(0 or I)#
Trunk to trunk connection
4
(Make no attended conference)
\&+
"/
This specifies whether to allow for a trunk to trunk
connection between the two parties on outside
lines during a three - party conference call by
pressing the line key for either of the outside lines.
O#: Trunk to trunk connection not oossible
l#: Trunk to trunk connection possible
Note:
This function should be set to
enable
trunk
to trunk connection on outside lines
beforehand.
-35-