Muratec MFX-2590 Administrator's Manual page 93

Item
IPv6 Setting
Note
• You can also specify TCP/IP settings using
3, "Setting the Connection Environment" in the OfficeBridge Guide.
• Make sure to obtain permission from the network administrator before changing
the IP address. Improperly changing the IP address may cause the network to stop
functioning normally.
„ Opening the TCP/IP Settings Screen
1
Press <Setting>.
2
Press the [Management] tab.
3
If an administrator password is set,
If an administrator password is not set, proceed to step 5.
4
Enter the administrator password, and press [Enter].
5
Press [Network Settings].
6
Press [TCP/IP Settings].
7
Specify each setting.
2-44 Specifying the Network Settings
You can set the following settings:
Obtain IPv6 address
l
Link Local Address
l
Global IP Address
l
Subnet Prefix Length
l
Default Gateway
l
For details on the IPv6 settings, refer to Chapter 3, "Setting the
Connection Environment" in the OfficeBridge Guide.
OfficeBridge. For details, refer to Chapter
press [Admin Password].
Description