GCC Technologies Expert Pro Series User Manual page 32

sacrificing quality. Whereas Quality Mode offers the highest
quality, sacrificing output speed. Keep in mind that speed and
quality are usually at a tradeoff.
Square Cut To perform a cutting test at present blade position.
For more information, please refer to "4.3 Adjusting the
Cutting Force and Offset" to adjust blade force and cutting
speed.
Redo Last Plot Recut:
To repeat the last job without re-sending the data.
Copy:
To copy the last job without re-sending the data.
* 1mm gap will be auto-generated between 2 copies).
* If the media length is not enough to continue, it will show
below message on LCM:
* If both functions are enabled at the same time, the cutter will
perform the last setting only.
To clear up buffer memory.
Set Smoothing To enable smooth-cutting function.
Cut
Over Cut To generate an overcut to facilitate weeding.
Set Tangential To enable the emulated tangential-cutting mode for thicker
Mode media types and small letter cuts.
Note: while the Offset value setting at 0.000 mm, "Set
Tangential Mode" will automatically be disabled.
Panel Setup Accept setup command:
To accept commands of the Force, Speed, Cutting Quality,
and Offset only via software.
Control panel only:
To accept commands of the Force, Speed, Cutting Quality,
and Offset only via control panel of the cutter.
Restore Default To turn all parameters of the menu items to factory-default
settings.
Save To save pattern(s) of cutting parameters for later use.
Parameter
Auto Unrolled To avoid paper jam and motor crash by automatically unroll
Media media (50cm and up) before cutting while enabled. .
* Auto-unroll only effects on roll/edge media.
* Using Single mode to size media will disable this function
automatically.
* If the length of the rolled media is less than 2 meters or the
weight is light, it is recommended to set this mode disabled.
The Control Panel
[ CUT TEST ]
O u t O f S p a c e
o f C o p i e s f i
[ DATA CLEAR ]
[ TOOL SELECT ]
; #
n i s h e d
[ MISC ]
3-5
Expert Pro User Manual
1~99;
1 per step
1~99;
1 per step
Enable
0.00mm-1.00mm 0.00mm
0.05mm/per step
Disable
Disable