Technical Data - Hilti DX460 Operating Instructions Manual

Fasteners
Ordering designation
X-DNI, X-ZF
X-SL
X-EDNI
X-CR
X-AL-H
X-FS
X-SW
23/36 mm
X-(E)M/W/6/8 ... P8,
X-M/W10 ... P10
For further equipment contact your local Hilti organisation.

4. Technical data

DX 460 tool
Weight
Tool length
Nail length
Recommended maximum fastening rate per hour
Cartridges
Power regulation
MX 72 magazine
Weight
Nail length
Magazine capacity
Right of technical changes reserved
20
Application
Nails with differing application profile for a wide variety of fastenings.
Easily removable formwork nail for temporary fastenings
Magazined standard nails for efficient fastening to steel.
Stainless-steel nails for fastenings in damp or corrosive surroundings.
High-strength nails for fastening to steel and concrete of higher strength.
The ideal fastener to position formwork.
Flexible washer fasteners to fasten insulating foils / sheeting to concrete and steel.
Washers for Hilti nails: simple securing of joint seals, foils / sheeting and timber to
concrete and steel using the X-460 WH23/36 washer holder
Studs for bolted fastenings on concrete and steel.
3.25 kg (7.16 lb),
3.51 kg (7.78 lb) with magazine
458 mm (18.03"),
475 mm (18.7") with magazine
Max. 72 mm (2 7 /
")
8
700/h
6,8/11 M (27 cal. short) green, yellow, red, black
4 cartridge power levels, regulation wheel with locking
function
0.653 kg (1.44 lb)
Max. 72 mm (2 7 /
")
8
Max. 13 nails