Technical Data; Before Use; Operation - Hilti DX 351 BT Operating Instructions Manual

Cleaning set
Hilti spray, flat brush, round brush 19/31 mm, round brush 4.5 mm, round brush 9 mm, cleaning cloth, scraper

5. Technical data

Tool
en
Weight
Length of tool
Cartridges
Recommended max. fastener driving frequency:
Cocking movement
Cocking pressure
Right of technical modification reserved

6. Before use

6.1 Tool inspection
Ensure that there is no cartridge strip in the tool. If
●
there is a cartridge strip in the tool, remove it by hand
from the tool.

7. Operation

The base material may splinter when a
●
fastener is driven or fragments of the
cartridge strip may fly off.
Flying fragments may injure parts of the
●
body or the eyes.
Wear safety glasses and a hard hat (users
●
and bystanders).
The nail or stud is driven by a cartridge
●
being fired.
Excessive noise may damage the hear-
●
ing.
Wear ear protection (users and
●
bystanders).
20
Printed: 20.08.2013 | Doc-Nr: PUB / 5069824 / 000 / 02
-WARNING-
-CAUTION-
DX 351 BT
2.28 kg (5 Ibs)
403 mm (15.9")
6.8/11 M (27 cal. short)
brown
700/h
59 mm (2.3")
100 N
Check all external parts of the tool for damage at reg-
●
ular intervals and check that all controls operate prop-
erly. Do not operate the tool when parts are damaged
or when the controls do not operate properly. If nec-
essary, have the tool repaired at a Hilti service centre.
Check the piston for wear (see "8.4 Care and mainte-
●
nance").
Under certain circumstances, the tool
●
can be made ready to fire by pressing it
against a part of the body (e. g. a hand).
When in the "ready to fire" state, a fas-
●
tener or piston could be driven into a part
of the body.
Never press the nosepiece of the tool
●
against parts of the body.
Under certain circumstances, the tool
●
can be made ready to fire by pulling back
the fastener guide by hand.
When in the "ready to fire" state, a fas-
●
tener or piston could be driven into a part
of the body.
Never pull back the fastener guide by
●
hand.
DX 351 BTG
2.36 kg (5.2 Ibs)
431 mm (16.9")
6.8/11 M (27 cal. short)
brown
700/h
59 mm (2.3")
100 N
-WARNING-
-WARNING-