3.10 Gas can
Note
Observe the safety instructions provided with the gas can!
In order to operate the fastening tool, the gas can must be inserted in the gas can compartment.
The gas can status can be read from the LED display after pressing the ‚GAS' button.
The gas can must be removed before breaks between working, before maintenance and before transporting
or storing the fastening tool.
3.11 Indication of gas can status
After pressing the ‚GAS' button, the LED display indicates the status of the gas can.
Status
All four LEDs light green.
Three LEDs light green.
Two LEDs light green.
One LED lights green.
One LED blinks green.
One LED lights red.
4 Technical data
4.1 Fastening tool
Weight (empty)
Application temperature, ambient temperature
Maximum fastener length
Fastener diameter
Compression stroke
Magazine capacity in strips of 10 nails (Magazine capac-
ity)
Maximum fastener driving frequency (Fasteners per hour)
4.2 Noise information in accordance with EN 60745
Sound (power) level (L
Uncertainty for the sound power level (K
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
4.3 Total uniaxial vibration value (in z-direction)
The vibration emission level stated in these instructions has been measured in accordance with a standardized
test given in EN 792-13/ISO 11148-13 and may be used to compare one direct fastening tool with another.
8
)
WA
)
WA
)
pA
pA
Meaning
•
Level is approx. 100 %.
•
Level is approx. 75 %.
•
Level is approx. 50 %.
•
Level is approx. 25 %.
•
Level is below 10 %. Replacement of the gas
can is recommended.
•
There is either no gas can in the fastening tool,
the wrong type of gas can is fitted or the can is
empty.
Note
Even when the level is indicated as "empty", the gas
can, for technical reasons, still contains a little gas.
3.9 kg
(8.60 lb)
−10 ℃ ...45 ℃
(14.0 ℉ ...113.0 ℉)
≤ 39 mm
(≤ 1.54 in)
•
2.6 mm (0.102 in)
•
3 mm (0.12 in)
40 mm
(1.57 in)
1 ...4
1,200
0 dB(A)
0 dB(A)
0 dB(A)
)
0 dB(A)