Technical Data; Safety Instructions - Hilti SMD 57 Operating Instructions Manual

5 Technical data

Right of technical changes reserved.
Magazine
Weight
Length
en
Contact pressure
Screw capacity (screws per strip)
Suitable drywall screw types
Length
Thread inside diameter
Head diameter
Drive type
Philips no. 2 can be driven with the following Hilti
screwdrivers

6 Safety instructions

6.1 Personal safety
a) Stay alert, watch what you are doing and use
common sense when operating a power tool. Do
not use a power tool while you are tired or under
the influence of drugs, alcohol or medication. A
moment of inattention while operating power tools
may result in serious personal injury.
b) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to
be performed. Use of the power tool for opera-
tions different from those intended could result in a
hazardous situation.
c) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and
any other condition that may affect the power
tool's operation. If damaged, have the power tool
repaired before use. Many accidents are caused by
poorly maintained power tools.
d) Store idle power tools out of the reach of chil-
dren and do not allow persons unfamiliar with the
power tool or these instructions to operate the
power tool. Power tools are dangerous in the hands
of untrained users.
e) Dress properly. Do not wear loose clothing or
jewellery. Keep your hair, clothing and gloves
away from moving parts. Loose clothes, jewellery
or long hair can be caught in moving parts.
f) Use personal protective equipment. Always wear
eye protection. Protective equipment such as dust
mask, non-skid safety shoes, hard hat, or hearing
8
SMD 57
Without screwdriver, Without screw strip: 0.35 kg
186 mm
to 40 N (4.0 kp)
50
SMD 57
9...57 mm
3...4.5 mm
7.5...8.6 mm
Philips no. 2 (S‑MBL 116 PH2)
SF 4000 / SF 4000‑A / SD 5000 / SD 2500 / SD 4500 /
SD 5000‑A22 / SD 4500‑A18 / SD 45
protection used for appropriate conditions will reduce
personal injuries.
6.2 General safety rules
a) Observe the operating instructions and the safety
rules contained for the magazine and the screw-
driver used.
b) Always work with the screwdriver running at max-
imum speed. Accordingly, use the switch lockbut-
ton on the screwdriver.
c) Do not hold the SMD 57 magazine in the area of
the depth gauge.
d) Each screwdriving stroke must be completed in
full. Interruption of the magazine stroke or release of
pressure half way through the screwdriving operation
may lead to malfunctions.
e) Change the screw strip only when the screwdriver
is switched off.
f) Wear eye protection, especially when working
overhead.
g) Use only genuine Hilti S‑MBL 116 PH2 bits. Check
that the bits are in good condition.
h) Use only genuine Hilti screw strips and screws.
i) Always work at right angles to the surface of the
workpiece to be fastened.
j) Store the screw strips in a straight position, as
they are in the original package.