Oce CS171 User Manual page 381

Troubleshooting
Symptom
The "Conflicts" mes-
sage with "Unable to
Select" or "Function
Canceled" appears.
Printing is not per-
formed as specified.
The watermark cannot
be printed.
The staple function
cannot be specified.
Stapling cannot be
performed.
The stapling position
is not as expected.
The hole punch func-
tion cannot be speci-
fied.
The pages are not
punched.
The hole punch posi-
tion is not as expect-
ed.
The form is not printed
properly.
The image is not print-
ed properly.
CS171P
Probable Cause
An incorrect combination of func-
tions has been specified.
Incorrect settings are specified.
A combination of functions, al-
though possible in the printer driv-
er, is not possible with this
machine.
The paper size, orientation, and
other settings specified in the ap-
plication have priority over those
specified in the printer driver.
The watermark is not correctly
set.
The watermark density is set to a
level that is too low.
Watermarks cannot be printed in
graphics applications.
Stapling is not possible if "Paper
Type" is set to "Thick" or "Trans-
parency".
The staple function requires op-
tional Finisher FS-501 or FS-603.
Stapling is not possible if the doc-
ument contains pages of different
sizes.
The orientation setting is not cor-
rect.
Hole punching cannot be speci-
fied if "Booklet" is selected or pa-
per not compatible with the
finisher is used.
If optional Finisher FS-603 is in-
stalled, the punch kit is required.
Printed pages may be fed out
without being punched if the pa-
per is loaded into the paper
source with an incorrect orienta-
tion.
The orientation setting is not cor-
rect.
Available computer memory
space is not sufficient.
Available computer memory
space is not sufficient.
Action
Check the settings and specify
the functions correctly.
Check each setting in the printer
driver.
Enter the correct settings in the
application.
Check the watermark settings.
Check the density settings.
No watermark can be printed in
this case.
Check each setting in the printer
driver.
Install the required optional finish-
er and enable it using the printer
driver.
Check the document.
Check the stapling position in the
printer driver setup dialog box.
Check each setting in the printer
driver.
Install the required optional finish-
er and enable it using the printer
driver.
Check the orientation setting.
Check the punch position on the
Layout tab of the printer driver
setup dialog box.
Simplify the form to reduce the
data size.
Simplify the image to reduce the
data size.
8
8-39