Table of Contents
Advertisement
Chapter 2 Getting Started — Attaching/removing the projection lens (optional)
Attaching/removing the projection lens (optional)
Move the projection lens to the home position before replacing or removing the projection lens. (x page 52)
Attention
f Replace the projection lens after turning off the power of the projector.
f Do not touch the electric contacts of the projection lens. Dust or dirt may cause poor contact.
f Do not touch the surface of the projection lens with your bare hands.
f Before attaching the projection lens, remove the lens cover attached to the projection lens.
Attaching the projection lens
Attach the projection lens using the following procedure.
1)
Remove the lens mount cover.
f Remove the lens cover by pulling the lens mount cover towards you while holding the left and right button part from both the upper and
lower side.
2)
Insert the projection lens by aligning the mark on the projection lens (orange) with the mark on the
projector (E to the left of LOCK) and turn clockwise until it clicks. (Fig. 1).
3)
Secure the projection lens with the lens fixing screw supplied. (Fig. 2)
f Use a Phillips screwdriver to secure it in screw hole A located to the right of mark on the projection lens (orange).
f Some lenses may not have a screw hole A for securing the projection lens.
4)
Attach the lens mount cover.
Attention
f Turn the projection lens counterclockwise to confirm that it does not come out.
Removing the projection lens
Remove the projection lens using the following procedure.
1)
Remove the lens mount cover.
f Remove the lens cover by pulling the lens mount cover towards you while holding the left and right button part from both the upper and
lower side.
Fig. 1
Lock button
Fig. 1
Screw hole A
Lens fixing screw
Fig. 2
ENGLISH - 41
Advertisement
Table of Contents
