Table of Contents
Advertisement
[COMMAND]
[INPUT]
[LAMP SELECT]
[P IN P]
11) Press the <ENTER> button.
f The command is fixed and n is displayed at the left of the selected command.
f After the command is fixed, press the <MENU> button to close the detailed setting screen.
12) Press asqw to select [STORE], and press the <ENTER> button.
Note
f If you attempt to register the setting that would make the lamp turn on for a short time, an error message will be displayed on the screen.
Set the time and command again.
f To delete a command already set, press the <DEFAULT> button on the remote control at the screen in Step 5), or select [DELETE] at the
screen in Step 6) and press the <ENTER> button.
f If multiple commands have been set for the same time, they are executed in chronological order starting from the smallest command
number.
f The operating time will be the local time. (x page 108)
f If an operation is executed with the remote control or control panel of the projector or with a control command before the command set in
[SCHEDULE] is executed, the command set with this function may not be executed.
[STARTUP INPUT SELECT]
Set the input when the projector is switched on to start projection.
1)
Press as to select [STARTUP INPUT SELECT].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[LAST USED]
[VIDEO]
[RGB1]
[RGB2]
[DVI-D]
[HDMI]
[SDI]
[RS‑232C]
Set the communication conditions of the <SERIAL IN>/<SERIAL OUT> terminal.
Setting the communication condition of the <SERIAL IN> terminal
1)
Press as to select [RS‑232C].
2)
Press the <ENTER> button.
f The [RS‑232C] screen is displayed.
104 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Detailed settings of
[COMMAND]
[VIDEO]
[RGB1]
[RGB2]
[DVI-D]
[HDMI]
[SDI]
[SINGLE]
[DUAL]
[TRIPLE]
[QUAD]
[OFF]
[USER1]
[USER2]
[USER3]
Keeps the input selected last.
Sets the input to VIDEO.
Sets the input to RGB1.
Sets the input to RGB2.
Sets the input to DVI-D.
Sets the input to HDMI.
Sets the input to SDI.
Description
Switches the input to VIDEO.
Switches the input to RGB1.
Switches the input to RGB2.
Switches the input to DVI-D.
Switches the input to HDMI.
Switches the input to SDI.
Turns on one lamp. (The lamp with shorter runtime will
automatically light.)
Turns on two lamps. (The lamp with shorter runtime will
automatically light.)
Turns on three lamps. (The lamp with shorter runtime will
automatically light.)
Turns on all four lamps.
P IN P function is not used.
Lays out the sub-screen with the settings of [USER1].
Lays out the sub-screen with the settings of [USER2].
Lays out the sub-screen with the settings of [USER3].
Advertisement
Table of Contents
